Saxby Lighting 43810 Manual

V2 17/06/2021
www.saxbylighting.com Saxby Lighting
EU Manufacturer: Brilliant AG,
Brilliantstrasse 1, D-27442 Gnarrenburg
UK Manufacturer: BH17 7BY
Instruction leaflet
LED Driver Constant Voltage
43810
parallel
the correct configuration.
being fitted and the total wattage of these units. We
recommend a maximum load of 10W for the LED
Driver.
LED driver is now ready for use.
Commissioning
240V
~
50Hz
Constant Voltage
LED Driver
+
_
+_+_+_
Fitting Fitting Fitting
cleaning.
Recycling advice
Safety information
We recommend cleaning with a soft dry cloth. Never
use scourers, abrasives or chemical cleaners.

Warning
This LED driver is Double Insulated and
does not require connection to an Earth
circuit.
Please read these instructions carefully before
electrician.
Install in accordance with IEE Wiring regulations and
before installing or maintaining this fitting. Ensure
with household waste. Please recycle where facilities
recycling advice.
Specification
Layout
ensuring the cables will reach the distances between
the LED driver and each LED fitting.
driver.
damaged.
layout so that the mains cable is the longer length.
We recommend that a maximum total cable length of
5.0m is used on the low voltage side.
existing fitting, carefully note the position of each set
of wires.
the system will connect to. Do not connect at this
stage. Ensure that the LED driver can be accessed
the negative terminal.
loose strands have been left out of the connection
ensuring that
loose strands have been left out of the connection
Direct Wiring
This LED driver is double insulated and must not be
earthed.
or is removed for any other reason, then the cut off E
L
N
Fuse
BL
Neutral
Live
Plug Wiring
Check that...
No loose strands have been left out of the connection