SECO-LARM Enforcer SH-816S-SQ Series User manual

®
Self-Contained Siren or Siren/Strobe
Manual
Features:
9~15 VDC
Low current draw
120dB Warble-tone siren
25W Speaker (siren and speaker input
cannot be connected at the same time)
Audio input can be used for broadcast
Built-in tamper alarm output
Easy installation
Weatherproof for outdoor/indoor use, IP65
Mount directly to wall or to most common
back boxes
In addition to the above, SH-816S-SQ adds:
Bright xenon tube strobe light
Strobe can be triggered separate from siren
Strobe available in amber, clear, blue, or red
SH-816S-SQ/R shown
SH-816S-BQ Siren
SH-816S-SQ/x* Siren/Strobe
*Replace "x" with the first letter of the lens color, amber, clear, blue, red.

ENFORCER Self-Contained Siren or Siren/Strobe
2SECO-LARM U.S.A., Inc.
The ENFORCER Siren/Strobes are multi-purpose devices: siren, speaker, and optional strobe
(SH-816S-SQ onl
y)
. It can serve as a re
g
ular siren, but also has an audio input that can be used to
playback audio or broadcast messages. The SH-816S-SQ series also includes a strobe li
g
ht with a
choice of amber, blue, clear, or red lenses and can be surface installed or to a standard single
gang, double gang or C-type back box.
1x Siren unit 4x Mounting screws 4x Plastic wall anchors
1x Back removal tool 1x Manual
Model SH-816S-BQ SH-816S-SQ
Type Siren Siren/Strobe
Operating voltage 9~15 VDC
Current draw
(max.)
Strobe N/A 190mA@12VDC
Siren 680mA@12VDC
Both 870mA@12VDC
Siren volume 120dB
Speaker rating 25W Peak
Strobe flash rate N/A 75 per minute
Tamper output 100mA@30 VAC/VDC
IP Rating IP65
Operating humidity 0~95%
Operating temperature -4°~131° F (-20°~55° C)
Housing material White polycarbonate plastic
Dimensions 61/8"x415/16"x41/2" (155x126x115 mm) 61/8"x7"x41/2" (155x178x115 mm)
Weight 1-lb 13-oz (812g) 2-lb 2-oz (957g)
Specifications:
Overview:
Introduction:
Parts List:
Siren/Strobe
61/8" (155mm) 41/2" (115mm)
61/8" (155mm) 41/2" (115mm)
415/16"
(126mm)
Siren
7"
(178mm)

ENFORCER Self-Contained Siren or Siren/Strobe
SECO-LARM U.S.A., Inc. 3
Installation:
1. Determine the desired location and
installation—surface or to a back box.
2. Remove the two screws from the two
tabs that attach the back to the main
unit (See Fig. 1).
3. Squeeze the included back removal tool
and insert through the wiring access
hole in the back of the unit. Release and
pull carefully until the back is removed
from the unit.
4
.Thread the wires (up to 8 wires,
depending on installation, see "Sample
Applications" on pg. 4) through the
center hole in the back and install the
back to the wall/backbox using the four
mounting holes in the back oriented so
that the engraved arrow is pointing up.
Be careful not to use the hole for the
tamper switch (see Fig. 2).
NOTE: For non-standard boxes, drill
out any of the other holes
engraved in the oval
indentations on the back
5. Connect the wires for the desired
installation to the terminals as shown in
Fig. 3 and referring to the sample
applications on pg. 4.
6. Carefully slide the main unit onto the
back, ensuring the correct orientation
(note the notch and the arrows) and that
the terminal plugs are correctly engaged
(see Fig. 1).
7. Attach the main unit to the back using
the two screws removed in step 2.
Fig. 2
Mounting holes
Mounting holes Tamper
switch
hole
STROBE
+12VDC
GND
GND
SIREN
+12VDC
TAMPER
TAMPER
SPEAKER
SPEAKER
Wiring
access
hole
Orientation
alignmen
t
notch
Fig. 3
Wiring terminals
STROBE
+12VDC
GND
GND
SIREN
+12VDC
TAMPER
TAMPER
SPEAKER
SPEAKER
Fig. 1
Tamper switch
Orientation
alignment
notch
Tamper
switch
hole
Back
removal
tool

ENFORCER Self-Contained Siren or Siren/Strobe
4SECO-LARM U.S.A., Inc.
Also Available from SECO-LARM®:
Sample Applications:
SECO-LARM
® U.S.A., Inc.
16842 Millikan Avenue, Irvine, CA 92606 Website: www.seco-larm.com
Phone: [phone] | [phone] Email: [email protected]
PICAN4
MI_SH-816S-xQ_190910.docx
NOTICE: The SECO-LARM policy is one of continual development and improvement. For that reason, SECO-LARM
reserves the right to change specifications without notice. SECO-LARM is also not responsible for misprints. All trademarks
are the property of SECO-LARM U.S.A., Inc. or their respective owners. Copyright © 2019 SECO-LARM U.S.A., Inc. All
rights reserved.
WARRANTY: This SECO-LARM product is warranted against defects in material and workmanship while used in normal
service for one (1) year from the date of sale to the original customer. SECO-LARM’s obligation is limited to the repair or
replacement of any defective part if the unit is returned, transportation prepaid, to SECO-LARM. This Warranty is void if
damage is caused by or attributed to acts of God, physical or electrical misuse or abuse, neglect, repair or alteration,
improper or abnormal usage, or faulty installation, or if for any other reason SECO-LARM determines that such equipment
is not operating properly as a result of causes other than defects in material and workmanship. The sole obligation of
SECO-LARM and the purchaser’s exclusive remedy, shall be limited to the replacement or repair only, at SECO-LARM’s
option. In no event shall SECO-LARM be liable for any special, collateral, incidental, or consequential personal or property
damage of any kind to the purchaser or anyone else.
IMPORTANT: Users and installers of this product are responsible for ensuring this product complies with all national,
state, and local laws and statutes related to monitoring and recording audio and video signals. SECO-LARM will not be
held responsible for the use of this product in violation of any current laws or statutes.
STROBE
+12VDC
GND
GND
SIREN
+12VDC
A
udio or
Broadcast
System*
Alarm
System
A
udio or
Broadcast
System*
Alarm
System
12VDC
Power
Supply
Triggering
Device
Triggering both siren and strobe together
(also showing audio input) Siren and strobe triggered by separate devices
(also showing audio input)
Siren
Triggering
Device
12VDC
Power
Supply
Strobe
Triggering
Device
(+)
TAMPE
R
TAMPE
R
SPEAKE
R
SPEAKE
R
(
–
)
(
–
)
(+)
STROBE
+12VDC
GND
GND
SIREN
+12VDC
(+)
(+)
(
–
)
(+)
(
–
)
TAMPE
R
TAMPE
R
SPEAKE
R
SPEAKE
R
(
–
)
OR
OR
Electronic Chimes Dual-Tone Wall Sirens LED Strobe Lights
SH-512BQ shown SH-525SQ shown SL-1301-SAQ shown
*IMPORTANT: Speaker and siren input cannot be connected at the same time.