Sony Ipela PCS-XC1 User manual

POWER ONLINE
HDMIIN(PC) HDMI OUT
MAINTENANCE MIC
19.5V
to
(USB) port
Wacom pen
tablet
(not supplied)
TV monitor
(not supplied)
to HDMI IN
HDMI cable
(supplied)
Computer
to HDMI OUT
to HDMI OUT
HDMI cable
(not supplied)
to HDMI IN (PC) to
UTP cable (Category 6,
straight, not supplied)
PCS-A1 microphone (supplied)
to MIC
to DC 19.5V
AC adapter
(supplied)
Power cord (supplied)
to power outlet
LAN
4-545-842-11 (1)
HD Visual Communication System
PCS-XC1
Installation Guide
© 2014 Sony Corporation Printed in China
Connections
Continued on
reverse side
Caution
Be sure to turn off all equipment before making connections.ˎ
For safety, do not connect the 1000BASE-T connector to a networkˎ
that will apply excess voltage to the connector.
Do not connect small USB devices to the USB port on the front ofˎ
the unit, as they may become impossible to remove. Connect small
devices to the USB port on the rear of the unit.
Note
We recommend using Sony HDMI cables.
Front Rear

Changing the “Frequency” Setting
with the Remote Commander
If the “Frequency” setting in the Video setup menu is configured incorrectly, pictures will not be displayed on
the monitor. In such cases, use the (power) switch on the unit and the buttons on the Remote Commander
to configure the correct settings.
To change the “Frequency” setting
Wait at least 2 minutes after rebooting the unit, and then perform the following.
Press the (power) switch on the unit.
Within five seconds after you pressed the switch, press the buttons on the
Remote Commander as follows, based on the desired “Frequency.”
Desired “Frequency” On the Remote Commander, press:
60 Hz VIDEO INPUT button (once) Number button 1 (three times)
50 Hz VIDEO INPUT button (once) Number button 2 (three times)
The “Frequency” setting is changed, and the unit shuts down. Press the (power) switch on the unit
again to turn it on.
“IPELA” and are trademarks of Sony Corporation.