Sony PDBK-L1500 User manual

LINEAR EDIT KEY
PDBK-L1500
INSTALLATION MANUAL
1st Edition (Revised 1)
!警告
このマニュアルは，サービス専用です。
お客様が，このマニュアルに記載された設置や保守，点検，修理などを行うと感電や火災，人身
事故につながることがあります。
危険をさけるため，サービストレーニングを受けた技術者のみご使用ください。
設置や保守，点検，修理などを行う前に，PDW-HD1500 に付属している下記マニュアルの「安
全のために」を必ずお読みください。
.インストレーションマニュアルおよびオペレーションマニュアル
!WARNING
This manual is intended for qualified service personnel only.
To reduce the risk of electric shock, fire or injury, do not perform any servicing other than
that contained in the operating instructions unless you are qualified to do so. Refer all
servicing to qualified service personnel.
!WARNUNG
Die Anleitung ist nur für qualifiziertes Fachpersonal bestimmt.
Alle Wartungsarbeiten dürfen nur von qualifiziertem Fachpersonal ausgeführt werden.
Um die Gefahr eines elektrischen Schlages, Feuergefahr und Verletzungen zu
vermeiden, sind bei Wartungsarbeiten strikt die Angaben in der Anleitung zu befolgen.
Andere als die angegeben Wartungsarbeiten dürfen nur von Personen ausgeführt
werden, die eine spezielle Befähigung dazu besitzen.
!AVERTISSEMENT
Ce manual est destiné uniquement aux personnes compétentes en charge de l’
entretien. Afin de réduire les risques de décharge électrique, d’incendie ou de blessure
n’effectuer que les réparations indiquées dans le mode d’emploi à moins d’être qualifié
pour en effectuer d’autres. Pour toute réparation faire appel à une personne compétente
uniquement.

1-1 (E)
PDBK-L1500
Section 1
Installation
Purpose of this manual
This manual is the installation manual of the Linear Edit Key PDBK-L1500.
This manual is intended for use by trained system and service engineers, and describes
the information on installing the PDBK-L1500.
Related manuals
Besides this Installation Manual, the following manual is prepared for PDBK-L1500.
.PDW-HD1500 Maintenance Manual (Available upon request)
This manual describes the detailed maintenance information and repair information
of the PDW-HD1500 and the respective options that are required for parts-level
service.
For obtaining, contact your local Sony Sales Office/Service Center.

1-2 (E) PDBK-L1500
1-1. General Information for Installation
Parts configuration
The Linear Edit Key PDBK-L1500 consists of the following parts.
.DU-477C board assembly
.Installation manual
.Installation guide
. Format label C
.Attaching screws (two screws)
Supported model
.PDW-HD1500
n
.PDBK-L1500 can run on the PDW-HD1500 containing software version V1.5 or
higher.
If software version of the PDW-HD1500 is any version before V1.5, update the
software version of the PDW-HD1500. (Refer to the PDW-HD1500 Maintenance
Manual Volume 1 “1-10. Firmware Update”.)
On installation
The PDBK-L1500 consists of the DU-477C board.
Install the PDBK-L1500 and check that the PDBK-L1500 is properly installed
according to the installation procedure described in section 1-2 and higher.
VTR constant
n
When making the linear editing with the PDBK-L1500 installed, set the VTR constants
of the editing control unit (BVE-700/700A/2000) as described below.
1
A0
A1
A2
59.94i/59.94P/29.97P
System frequency VTR constants
50i/50P/25P
23.98P
2
96
96
96
3
00
00
00
4
96
7D
78
5
07
07
07
6
07
07
07
7
03
03
03
8
80
80
80
9
0A
0A
0A
10
07
07
07
11
FE
FE
FE
12
00
00
00
13
80
80
80
14
5A
4C
48
15
FF
FF
FF
16
5A
4B
48

1-3 (E)
PDBK-L1500
1-2. Installation Procedure
1-2-1. Installing the Board
1. Turn the main unit upside down.
2. Remove the five screws and remove the bottom panel assembly.
3. Connect the DU-477C board connector CN1 to the HPR-23 board connector
CN801.
4. Attach the DU-477C board with the two screws (PSW2.6 x6) supplied.
5. Attach the bottom panel assembly by reversing the steps of removal.
Bottom
panel
assembly
DU-477C
board
B3 x 6
B3 x 6
CN1
PSW2.6
x 6
HPR-23 board
CN801
Main unit
bottom side
should face
upward.
Bottom
panel
assembly
DU-477C
board
B3 x 6
B3 x 6
CN1
PSW2.6
x 6
HPR-23 board
CN801
Main unit
bottom side
should face
upward.

1-4 (E) PDBK-L1500
1-2-2. Attaching the Format Label
1. Peel off the old format label with a pair of tweezers.
2. Attach the new format label supplied to the top panel while fitting the label with
cutout on the top panel.
Format labelFormat label

1-5 (E)
PDBK-L1500
1-3. Settings after Installation
Check procedure
1. While pressing the [PAGE/HOME] button and the [SHIFT] button simultane-
ously, press the [MENU] button.
The MAINTENANCE MENU is displayed.
2. Rotate the [PUSH|SET] knob to select M2: SERVICE SUPPORT, and press the
[PUSH|SET] knob.
3. Rotate the [PUSH|SET] knob to select M22: OPTION STATUS, and press the
[PUSH|SET] knob.
4. Confirm that “ena” is displayed in the place corresponding to SD REC&PB, 24P
REC&PB and Linear Edit.
n
For more detailed information on the Maintenance Mode, refer to the PDW-HD1500
Operation Manual or the Maintenance Manual Volume 1.
MAINTENANCE MENU
M0:CHECK
M1:ADJUST
M2:SERVICE SUPPORT
M3:OTHERS
M4:SETUP MAINTENANCE
M5:NETWORK
M6:DRIVE
MAINTENANCE MENU
M0:CHECK
M1:ADJUST
M2:SERVICE SUPPORT
M3:OTHERS
M4:SETUP MAINTENANCE
M5:NETWORK
M6:DRIVE
OPTION STATUS
SD REC&PB : ena
24P REC&PB : ena
MPEG TS Board : ---
Linear Edit : ena
TO MENU : MENU KEY
OPTION STATUS
SD REC&PB : ena
24P REC&PB : ena
MPEG TS Board : ---
Linear Edit : ena
TO MENU : MENU KEY

Sony Corporation
PDBK-L1500 (WW) J,E
4-151-077-02
Printed in Japan
2009. 9 16
©2009