Spectrum Industries 55515 User manual

Assembly Instructions
0191564R1 Page 1 of 2
Assembly Instructions
Important
Before you begin, read and comply with all safety and operating instructions,
and ensure all parts and correct quantities are included.
Any parts damaged during shipment must be reported within 5 days of receipt.
To report information regarding missing parts or damage, to purchase parts
or accessories, or if you have any questions, please contact us.
www.spectrumfurniture.com
800-235-1262, 715-723-6750
Thank you for purchasing Spectrum products!
Accessory Shelf
55515
Tools
Required
21.8”W
15.8”W
(1) 0147901
Tray
(2) 0145039
Bar support B-side
(with slots)
(4) 056284
8-32 Wing nut
(2) 0142528
Bar support
(with threaded
weld studs)
(2) 042749
#8 x 1” PHSM
Hardware
Assemble bar supports
1. The bars should be assembled with the tabs facing away from
each other as shown in Figure 1.
2. Loosen the (2) wingnuts slightly.
3. Repeat for the 2nd set of bars.
1
X 2
Bar support B-side
(with slots)
Bar support
(with threaded weld studs)
8-32 Wing nut
(2 per assembly)
Tab
Tab
Figure 1

0191564R1 Page 2 of 2
925 FIRST AVENUE, CHIPPEWA FALLS, WI 54729 / 800-235-1262 / 715-723-6750 / WWW.SPECTRUMFURNITURE.COM
© 2019 Spectrum Industries Inc., All rights reserved.
Left slotted
uprights
Right slotted
uprights
Front bar Assembly
Rear bar Assembly
1. Determine the approximate location (height) you would like the shelf
to be mounted. The rear bar is (1) slot higher than the front.
2. Insert one tab into a slot in the left slotted upright. Figure 2.
3. Insert the opposite tab into the corresponding right slotted upright
and fully extend the bar assembly into place.
4. Lock the extended position of the bars by securely tightening the (2)
wingnuts. Be sure both wingnuts are tight.
5. Repeat for the 2nd set of bars.
Note: When determining the location of the shelf, be sure it will
clear any obstructions that may be inside the cabinet and enough
clearance (height) is provided for all devices.
Figure 2
Install bars into cart
2
1. Carefully set the empty accessory shelf onto both sets of bars. Be sure
the rear channel “hooks” the rear set of bars fully. Figure 3.1.
2. Install (2) #8 x 1” PHSM screws into the back of the module-this will
prevent removal. Figure 3.2.
Bars
Bars
Accessory shelf
Figure 3.1
Install accessory shelf onto bars
3(2) 042749
#8 x 1” PHSM
(2) #8 x 1” PHSM
Cart
Figure 3.2
(2) #8 x 1” PHSM