Steelcase Answer Low Cost Worksurfaces User manual

Page 1 of 7
939504742 Rev B
®
If you have a problem, question, or request, call
your local dealer, or Steelcase Line 1 at
888.STEELCASE (888.783.3522)
for immediate action by people who want to help you.
(Outside the U.S.A., Canada, Mexico, Puerto Rico,
and the U.S. Virgin Islands, call: 1.616.247.2500)
Or visit our website: www.steelcase.com
©2001 Steelcase Inc.
Grand Rapids, MI 49501
U.S.A.
Printed in U.S.A.
Answer®Low Cost Worksurfaces
page 6
page 7

Page 2 of 7
939504742 Rev B
Cantilever and Tie Strap
See Cantilever Assembly Direction 939504645
Center Support Panel
See End Panel Assembly Direction 939504646
End Panel
See End Panel Assembly Direction 939504646
Attaching Brackets page 4
Pedestal Filler
See Pedastal Filler Assembly Direction 939504604
Mounting Brackets page 3

Page 3 of 7
939504742 Rev B
27 1/2"
Mounting Worksurfaces
Step 1:
Step 2:
Mark height of worksurfaces to
27 1/2". Attach the support brackets
to the vertical junctions. A minimum
of 1 pilot hole per corner and side
support bracket is provided. All
other supports contain a minimum
of 2 pilot holes.
Lay worksurfaces on supports for
the entire workstation cluster
loosely securing each surface to
supports and adjust worksurfaces
for optimal appearance. Secure
screws starting with corner
workstation.

Page 4 of 7
939504742 Rev B
Primary
Wing
Wing
Primary
Attaching Adjoining
Worksurfaces
Place support plates as shown.
Secure a screw in all
available holes.

Page 5 of 7
939504742 Rev B
Corner Leg Combination
Pilot Holes Provided
Pilot Holes
Provided
11/16" Gap
Connecting Worksurfaces with Legs.
Pilot Holes
Provided

Page 6 of 7
939504742 Rev B
See page 2 for support
information

Page 7 of 7
939504742 Rev B
See page 2 for support
information