Steelcase Ology User manual

Ology™Boundary Screen
888.STEELCASE (888.783.3522)
www.steelcase.com
©2020 Steelcase Inc.
Grand Rapids, MI 49501
U.S.A.
®
Page 1 of 4
1360035001
141020 Rev B
T30
#2 SQUARE
5/32”

®
Page 2 of 4
1360035001
141020 Rev B
Dual SidedSingle Sided
Assemble Mounting Bracket
1) Using (3) M6 button head thread forming screws (provided)
attach the mounting bracket to underside of cross-tube
weldment.
TIP: Note hole positions used on single sided (see arrows),
centered on dual sided applications.
2a) Use a level to check for vertical orientation. 2b) Loosen
(6) button head screws using a 5/32" allen wrench, 2c) adjust
the interface bracket to vertical and 2d) retighten (6) button
head screws.
2a
2d
2b
2c
5/32”
.472"
(12mm)
3x
1

®
Page 3 of 4
1360035001
141020 Rev B
1” minimum
Attach the Boundary Screen
3a) Position boundary screen against bracket and check for
alignment of the pilot holes (6X), 3b) adjust the screen leveler
glides, if necessary, to match the pilot hole pattern to slots in
bracket, 3c) secure using (6X) #10-12 x .625 screws (provided).
TIP: Check screen for 1” minimum gap clearance and alignment
to work surface top. If necessary, loosen screws from Step 1,
make adjustment to screen position, then retighten screws securely.
3c 3b 3a
CAUTION: Failure to observe this procedure could
result in injury. Boundary screen is heavy & must be
held in place firmly until attachment is complete to
prevent the screen from falling.
Note: If not installed, install screen leveler glides prior to step 4.

®
Page 4 of 4
1360035001
141020 Rev B
Install Trim
4c
4b
4a
4a) Flex sides of trim cover open to overlap mounting bracket.
4b) engage “V-tabs” to slots, then 4c) push cover tight to
boundary screen.