Swisher PowerBlade PBB-7512 User manual

PBB-7512
Bombardier Models
500 Quest 4X4 03
500 Traxter 4X4 99-04
650 Traxter XT CVT 4X4 05
650 Quest 4X4 02-04
John Deere Models
500 Buck Auto 04-06
500 Buck Manual 05-06
500 Trail Buck 04-06
650 Trail Buck .EX, EXT 05-06
May fit additional models see Master List
Front
Caution: Do not exceed 5 MPH with the blade or it’s brackets installed
Remove the mount plate for trail riding where extra ground clearance is needed
1602 Corporate drive
P.O. Box 67
Warrensburg, MO 64093
1-877-627-5860
12997
Partial Frame View

1 Mount Plate Right 10512TK
2 Mount Plate Left 10511TK
3 Angle Bracket 10321TK
4 Nylock Nut 5/16-18 NB181
5 Hair Pin #39 NB127
6 Clevis Pin 10305
7 Bolt M8-1.25 X30 NB232
8 Nut M8-1.25 NB718
9 Flat Washer NB275
10 Lock Washer NB159
11 Bolt 5/16-18X1 NB501
Assembly Instructions
Note. Right and Left direction are from the operator position. The lower skid plate, If so equipped, may need
to be removed. Please retain plate and hardware to be reinstalled if the plate is removed..
1. Identify the right and left side plates. Place the mount plate up against the bottom of the frame. The
Blade Mounting Tabs should be pointing down and located toward the front of the ATV. This is the
final location of these Brackets.
2. Remove front, outside, foot rest bolt on each side of ATV. Angle bracket (item3) attaches to this
location
3. Mounting plates are bolted into the skid plate mounting locations. Remove the current skid plate
mounting bolts one at a time and install the mounting brackets as you replace bolts with the longer
boltsand spacer washers as provided.
4. Each of the four mounting bolts will require 4 flat washers to fill the space as shown.
5. Install all hardware before tightening. Tighten each fastener a little at a time to prevent binding.
1
2
3
4
5
6
7
89
10
11
Remove Skid Plate Bolt and replace
Install New longer bolt
Spaced down with washers