Teknion transit Operating and maintenance instructions

P-Top Worksurface (TWPS), Modified P-Top Worksurface (TWMP) Part and Product Identification
A1 - P-Top Worksurface
(TWPS) x1
Section:
Description: Page No:
Date:
Rev. No: 01
P-TOP & MODIFIED P-TOP WORKSURFACE
WORKSURFACES & COUNTERTOPS
May 2018 1 of 4
TST_204
transit Installation Guides
OR
A2 - Modified P-Top
Worksurface
(TWMP) x1
B - C-Leg Assembly
(TLCL) *
C - Semi-Suspended Monoleg
(TLSM) *
D - 1/4"-20 x 5/8" UNC-2A
Cross/Square Comb Truss
Hd Machine Screw Zinc
(E01-0098) *
E - #10 x 1" LG. Quadrex, Pan
Washer Head. ZP.
(E07-0077) *
A - Worksurface
C
B
A1
* Parts/Products listed for reference ONLY.

STEP 2: Flip the assembled Worksurface and Supports back into the original orientation.STEP 1: Lay the Worksurface upside down onto a clean surface. Align the holes on the Support
TLCL and TLSM with the holes on the Worksurface. Secure the support with the screws
provided.
NOTE: Refer to Installation Guide TST_260 for installtion of Semi-Suspended Monoleg
(TLSM) and refer to Installation Guide TST_261 for installation of C-Leg (TLCL).
Section:
Description: Page No:
Date:
INSTALL SUPPORTS FLIP ASSEMBLED WORKSURFACE
TST_204
2 of 4
May 2018
P-TOP & MODIFIED P-TOP WORKSURFACE
WORKSURFACES & COUNTERTOPS
transit Installation Guides
B
C
D E D

STEP 4: Align the holes on the C-Leg (TLCL) with the holes on the perpendicular
Worksurface. Secure the Worksurface with the screws provided.
STEP 3: Connect the Worksurface to the perpendicular Worksurface.
Section:
Description: Page No:
Date:
CONNECT WORKSURFACE SECURE WORKSURFACE
TST_204
3 of 4
May 2018
P-TOP & MODIFIED P-TOP WORKSURFACE
WORKSURFACES & COUNTERTOPS
transit Installation Guides
D
E

Section:
Description: Page No:
Date:
LEVEL THE WORKJSURFACE
May 2018 4 of 4
TST_204
P-TOP & MODIFIED P-TOP WORKSURFACE
WORKSURFACES & COUNTERTOPS
transit Installation Guides
STEP 5: Level the Worksurface by adjusting the glide on the Semi-Suspended Monoleg (TLSM) and the C-Leg (TLCL).