teko Astra-3321 User manual

Astra-3321
Wireless door opening
magnetic contact
detector
User Guide
Manufacturer:
ZAO NTC TEKO
420108, Russia, Kazan,
Gafuri str., 71
Tel.:[phone]
[email protected]
www.teko.biz
Made in Russia
Rev. 3321-v4_5_instr_en
1 FUNCTION
The detector is intended for detecting opening or
movement of structures made of magnetically non-
conducting materials (aluminum, wooden, plastic,
etc.), forming alarm notification and transmitting alarm
signal to the Security Hub via radio.
The detector provides measurement and transmission
via radio the residual capacity of the battery in Mode 2
(see below).The transmission interval is 12 sec (jump-
er installed on Rtst plug) or 60 sec (jumper not in-
stalled on Rtst plug).
The detector provides connecting the Astra-361 water
leakage detector or any other hardwired detectors with
normally-opened contacts. Wire length not more than
3 m.
2 SPECIFICATION
Actuation distance, mm............................ from 20 to 30
Recovery distance, mm............................ from 13 to 23
Wireless coverage range, m ....................................100
Operating frequency range, MHz.............................433
Power supply voltage, V......................... from 2.3 to 3.0
Overall dimensions, mm.......................... 109 × 34 × 27
Operating Conditions
Temperature range, °С.......................from - 20 to + 50
Relative air humidity, %.........................up to 98 at + 40 °С
without moisture condensation
3 DELIVERY SET
Delivery set includes: steering magnet –1 pc., jumpers
–6 pcs. (installed), battery (CR123A, 3V) - 1 pc. (in-
stalled), screw –4 pcs., mounting tape –3 pcs. (in-
stalled), user guide –1 pc.
4 MODES OF OPERATION
Setting operating mode of the detector and indica-
tion of notifications are possible within 10 minutes
after battery insertion!
Mode
Plug
Jumper
Mode 2* (compatible with
Security Hub)
Mode 1
Rmod
Test signal trans-
mission period**
12sec.*
60sec.
Rtst
Frequency 1* (433,42MHz)
(compatible with Security Hub)
Frequency 3 (434,42MHz)
Lit
External detectors
input control
Yes
No*
Ext
Control of external water leak
detector Astra-361.
Control of internal and
external magnetic contacts*
Emod
Internal magnetic contact
control *
Internal magnetic contact
not controlled
Int
* Factory setting.
**For Mode 2 only

5 ADDING TO THE SYSTEM
1) When using the detector with factory settings (Se-
curity Hub compatible), start adding from step 3), if it is
necessary to change the operation mode of the detector,
remove the detector cover.
2) For operating with Security Hub set the Frequency
1and operating Mode 2.
3) Start registration from the mobile app Security Hub
or desktop app. Registration starts for 45-60 sec.
4) Activate the battery by pulling out the protective
strip or re-install the battery.
In case of unsuccessful adding, remove the battery
and repeat procedure. Before installing it on again, wait
at least 20 sec. or briefly set the battery in reverse polari-
ty.
5) Make sure that the adding is successful on the
Security Hubmobile or desktop app.
6 INSTALLATION PLACE
When the protected structure is closed (doors, win-
dows, etc.), the distance between the control magnet
and the detector should not exceed 5 mm.
Installation on a door:
Installation on a window:
Installation on a metal door:
7 INSTALLATION PROCEDURE
1) Remove the cover if
the installation is
carried out using
screws and / or you
need to connect exter-
nal detectors.
2) Remove the PCB by bending back the hook on the
base.
3) Fix the detector and steering magnet to the selected
installation location using the screws supplied.
4) Connect the wires to the Zone, GND terminals and
install jumpers on the Ext or Emod plugs according to
the selected operating mode.
5) Re-install the battery.
6) Place the PCB.
7) Close the cover of the detector until click.
8 WARRANTY
Operational warranty period: 5 years from the date of
commissioning, but no more than 5 years 6 months
from the date of manufacture and subject to current
user guide requirements.