teko Astra-517 ver.P User manual

«Astra-517 ver. Р»
Optic-Electronic PIR Motion
Detector
(Volumetric Lens)
User Guide
Manufacturer:
ZAO NTC TEKO
420108, Kazan, Russia
Gafuri 71
[phone]
[email protected]
teko.biz
Made in Russia
Rev. 517p-v1_4_instr_en
1 FUNCTION
Detector is intended to detect unauthorized
access into enclosed protected area and to
generate alarm notification by opening of
signaling relay contacts.
The detector is resistant to the movement of
pets weighing up to 20 kg.
2 DETECTION ZONE
3 DELIVERY SET
Delivery set includes: dowel –2 pcs., screw –2
pcs., label –2 pcs., user guide –1 pcs.
4 SPECIFICATION
Range of detectable
moving speed, m/sec .................from 0.3 to 3.0
Power supply voltage, V................. from 8 to 15
Current consumption, mA, max..................... 15
Overall dimensions, mm.................70 ×51 ×41
Operation conditions
Temperature range, °С............ from - 30 to + 50
Relative air humidity, % .........up to 98 at + 25 °С
Without moisture condensation
5 NOTIFICATION
Notification
LED
Relay (TMP)
Boot mode
Flashes 1 time per
1 second after
turning on the pow-
er. Duration 60 sec
for
60 sec
Normal
Off
Alarm
Lights up 1 time
for 2.5 sec when
detecting a human
movement in the
detection zone
for
2,5 sec
Failure
On
until failure
elimination
Tampering
Off
ТМР
«» –relay closed,
« » –relay open,
«ТМP »–Tamper circuit open
Side view
Top view
2,4m
3m
9m
10m
5m
5m
10m

6 INSTALLATION PLACE
1) Recommended installation height is 2.2-2.4 m.
2) Install detector on bearing walls and carriers.
3) Alarm loop and power supply wires should
be located far from power cables.
To eliminate false alarm hazards
It is recommended to close all doors, air-vents,
switch off fans, air-conditioners and other
sources of intense air flows in the room during
protection period.
Not recommended installation places
7 INSTALLATION
1) Remove cover
2) Remove PCB
3a) Installation on a
wall
3b)Installation in a
corner
Orient detector base strictly according to
the picture!
4) Fix the base on the wall. Install PCB.
5) Connect the wires (see section 8)
6) Perform TEST pass (see section 9)
8 WIRING
Perform wiring to detector`s terminals in
accordance with control panel operating manual.
+12V, GND –power supply terminals.
RELAY –terminals for detector connection to
hardwired zone;
TMP –detector tampering control terminals;
9 TEST-PASS
1) Turn on detector power. LED indicator will
start flashing for a maximum of 60 seconds.
2) Perform a TEST pass across the protected
area at a speed of 0.5 m/s to determine the
sensitive zones. At the moment of detection
(LED indicator will light up for 2.5 seconds),
stop, mark this position,
then go back one step
and continue moving.
Repeat the test pass in
the opposite direction.
10 WARRANTY
Warranty period of operation - 5 years from the
date of commissioning, but not more than 5
years 6 months from the date of manufacture,
and subject to the requirements of the current
operational documentation.
Squeeze
the caps of
the mount-
ing holes
Squeeze
the caps of
the mount-
ing holes
b
c
hooks