VS 800 Series User manual

3
VS Vereinigte Spezialmöbelfabriken GmbH & Co.KG
Hochhäuser Straße 8 · 97941 Tauberbischofsheim · Tel.: [phone] · [email protected]
http://links.vs-service.com/downloads/70-380_V01_DEEN_Serie_800_Haengeschraenke-152349.pdf
Corner protectors:
These are located on the bottom side of the cabinets and
should usually be removed.
On the Web:
You can find these Instructions on the Web: (see header)
Use:
Please take account of the notes on the following pages.
Faults and service:
If any faults occur, please contact our Customer Service:
[email protected]
Maintenance and cleaning:
On the Internet: vs.de/kataloge/reinigung/en
Transfer und Disposal:
If the product is transferred to another party then it must be
accompanied by these Instructions. Please contact your re-
sponsible local authority department regarding environmen-
tally friendly disposal.
The indicated electric and electronic components must not
be disposed of with the ordinary waste.
They must be removed from the furniture unit
before the unit is sent for disposal.
They are to be disposed of at authorized collection
and return points.
ASSEMBLY INSTRUCTIONS: 70-380 V01 010820
Serie 800
Suspended cabinets.
Intended use (scope):
The current Serie 800 suspended cabinets is part of a compre-
hensive cabinet system. No liability is assumed for improper
use. Use (e.g. in workshops, storage areas, wet rooms) is not
considered as intended. VS Vereinigte Spezialmöbelfabriken
GmbH & Co. KG is not liable for any damage resulting from this.
General comments:
Before using the products, read these instructions carefully
and pay special attention to the safety instructions. Keep
these Instructions for future consultation and communicate
them to other users.
General note on safety:
The following symbols and notes are used in our Instructions
for Use:
Important! This symbol indicates an important
assembly note.
Caution! This symbol indicates a very
important note.

4
Suspended cabinets.
Wall mounting with the double suspension rail [Fig. 1].
Step 1:
Fasten the double suspension rail (1) to the wall. In the case
of lightweight walls, screw the double suspension rail into
the stand, possibly use a load compensation plate.
Screw position Left / Right [Fig. 3].
Screw the first screw between the distress and the outer edge.
Fasten the second screw approximately 8 cm from the first
screw.
Important!No relining allowed!
The rail must lie completely against the wall!
Step 2:
Suspend the cabinet.
Step 3:
Level the cabinet and adjust the cabinet to the correct
position using a cross-head screwdriver.
Height adjustment (2).
Depth adjustment (3).
Caution! When fixing to a lightweight partition wall,
make sure that the load is distributed correctly – if in
doubt, contact the manufacturer!
Before installation, there is a need to check the suitability of
the wall construction and to check that the fasteners are able
to withstand the forces that occur. If the supplied universal
set does not match the nature of the wall, appropriate screws
and fittings must be obtained from specialist dealers to
ensure safety.
Assembly or disassembly may only be carried out by trained
specialist personnel, since there is a risk of serious accidents
if the assembly is not carried out correctly. VS Vereinigte
Spezialmöbelfabriken GmbH & Co.KG assumes no liability for
incorrect or improper installation and operation.
Caution!
Always hang cupboards above 1m (top shelf)!
Important! Make sure that the screw heads are not
slip through the holes in the suspension rail!
1 3
2
53 mm
mind. 1 m bis zum Boden
4
(1)
(3)
(2)