WB Mfg 4-Legged Stool User manual

1
wibenchmfg.com 507 E. Grant St. Thorp, WI 54771 • P - 800.242.2303
4 & 5-Legged Stool
with Bolt-on Backrest
V040819 subject to change.
Assembly Instructions
Before you begin, please make sure all parts and proper quantities are included. (See Part Identier Key on next page) Any parts damaged during
shipment must be reported within 24 hours of receipt. To report information regarding damages or if you have any questions, please call 800.242.2303.
Step 1:
• On 4-Legged Stool, place bolt-on backrest
between the back leg frame.
• One 5-Legged Stool, place bolt-on backrest
between the two back leg frames.
Step 2:
• Insert ⁄” Allen head machine screws through
the most inner-mounting holes (circled in
red) located on the TOP of the 4 or 5-legged
frame.
• Make sure you align the most outer holes
before fastening ⁄” Allen head machine
screws. (See the two images between Step 2
to make sure you have everything aligned.)
Step 3:
• Place seat with inserts facing up on protected
table.
• Place 4 or 5-legged frame on the top and
align the most outer holes with the inserts of
the seat.
Step 4:
• Insert & tighten corresponding screw for
the seat you are mounting through the
most OUTER mounting holes located on the
bottom of the 4-legged frame. (See bottom
of page for corresponding screw with type of
seat.)
Step 4
Bolt-on backrest
Back Back
Step 1Step 1
Step 2Step 2
4-Legged Stool 5-Legged Stool
Back of stool Back of stool
Front of stool
4-legged stool shown as an
example. Seat is attached the
same for a 4 or 5-legged stool.
Front of stool
Incorrect
Correct
Hardwood Seat
Use (4) ¾”
Phillips Head
Wooden Screws
Lotz Armor Edge® Seat
Use (4) ¾” Allen
Head Machine
Screws
Urethane Cushioned
Seat w/ backrest
Hardware Pack: 04066934
Use (4) ¼-20 x 1⁄”
Joint Connector
Bolts w/loctite
Step 3
Laminate Seat Hardwood Seat Urethane Seat

2
wibenchmfg.com 507 E. Grant St. Thorp, WI 54771 • P - 800.242.2303
Part # Description Qty.
Hardware Pack
040162
(w/ backrest)
⁄” Allen head machine screws
(Used to attach backrest to stool frame)
4
¾” Phillips head wooden screws
(Used to attach Hardwood seat)
4
¾” Allen head machine screws
(Used to attach Laminate seat)
4
Hardware Pack
04066934
(w or wo/
backrest)
¼20 x 35mm joint connector bolts
(Used to attach Urethane cushioned seat w/ backrest)
4
¼20 x 30mm joint connector bolts
(Used only to attach Urethane cushioned seat without a
backrest - please discard.)
4
Lotz Armor Edge® stool seat 1
Hardwood stool seat 1
Urethane stool seat 1
Part Identifier Key
Tools Required
• 4mm Allen wrench OR
• 4mm Hex bit
• Drill extension
• Phillips head screwdriver OR
• Phillips drill bit
• Screw gun
4 & 5-Legged Stool
with Bolt-on Backrest