Weiser Powerbolt 2 User manual

The latch bolt will extend and retract. The lock will beep and the keypad will
turn green or red.
Green (with 2 beeps): The door has successfully learned the orientation of the
door. Continue to step 3.
Red (with 3 beeps): Make sure the door is unlocked and that you are using a
fresh set of batteries. Repeat step 1.
THE LEADER IN RESIDENTIAL SECURITY 213826 10/17
While the door is open and unlocked, enter the following default
Mastercode to teach the lock the orientation of the door:
1. Press 0-0-0-0.
2. Press . You will hear one beep.
3.Press 0.
4.Press .
1
Press the button. The door will unlock.
4
3
2
How to Perform the Door Handing Process:
Press the button. The latch bolt will extend to lock.
Enter the default User Code (1-2-3-4).
5
IMPORTANT: It is recommended that you replace the default
Mastercode and default User Code with codes of your own.
12 4
35
67 9
80
Programming Video: https://www.youtube.com/watch?v=eZSwXjcYwAQ
Installation Video: https://www.youtube.com/watch?v=Aomf7oqslas

Press . You will hear one beep.
THE LEADER IN RESIDENTIAL SECURITY 213826 10/17
Make sure the lock is unlocked and the door is open. Enter your existing
Mastercode.
1
Enter a new User Code. It must be 4-10 digits.
Press . You will hear two beeps if successful. If you hear three beeps, it
was unsuccessful. Repeat from step 1 slowly.
4
3
2
How to Add a Code:
Press 1 - 9.
Press . You will hear one beep.
5
6

How to Remove a Code:
THE LEADER IN RESIDENTIAL SECURITY 213826 10/17
2Press . You will hear one beep.
Make sure the lock is unlocked and the door is open. Enter your existing
Mastercode.
1
4Press . You will hear one beep.
6Press . You will hear two beeps if successful. If you hear three beeps, it
was unsuccessful. Repeat from step 1 slowly.
3Press 3.
5Enter the User Code you wish to delete.
7Test the code: While your door is open, lock it. Enter the User Code, then
press . The door should not unlock.