Weiser Smartcode 10 User manual

How to Perform the Door Handing Process
THE LEADER IN RESIDENTIAL SECURITY 213826 10/17
2Make sure the door is open and the latch is extended.
Install 4 AA batteries in battery pack.
1
4Insert the battery pack and continue holding the Lock button.
3Press and hold the Lock button. Do not release.
5The latch bolt will retract and extend to learn the locking and unlocking direction
of the door. Status LED will indicate success or failure.
Success: LED flashes green
Failure: LED remains solid red
Programming Video: https://www.youtube.com/watch?v=WZSMIYoiuhM&t=49s

THE LEADER IN RESIDENTIAL SECURITY 213826 10/17
Use a phillips screwdriver to remove the 2 set screws on the interior of
the lock. Remove cover and set aside.
1
If programming is successful.
If programming is unsuccessful.
Green
(x1) (x1)
Red
(x3) (x3)
4
3
2Make sure the door is open. Press the round program button that was
under the cover you removed.
How to Add a Code:
Enter new user code. Each user code must be a unique code between 4
and 8 digits.
Press the “Lock” button once.

How to Remove a Code:
THE LEADER IN RESIDENTIAL SECURITY 213826 10/17
2Make sure the door is open. Press the round program button that was
under the cover you removed.
Use a phillips screwdriver to remove the 2 set screws on the interior of
the lock. Remove cover and set aside.
1
4Enter new user code.
6Re-enter new user code.
3Press the “Lock” button once.
5Press the “Lock” button once.
7Press the “Lock” button once.