ACME V Inground VI-10QW User manual

Innovation,Quality,Performance
DeclarationofConformity
Wedeclarethatourproducts(lightingequipments)complywiththe
followingspecificationandbearsCEmarkinaccordancewiththeprovision
oftheElectromagneticCompatibility(EMC)Directive89/336/EEC.
EN55103‐1:2009;EN55103‐2:2009;EN62471:2008;
EN61000‐3‐2:2006+A1:2009+A2:2009;EN61000‐3‐3:2008.
&
HarmonizedStandard
EN60598‐2‐17:1989+A2:1991;EN60598‐1:2008+A11:2009
EN62471:2008;EN62493:2010
Safetyofhouseholdandsimilarelectricalappliances
Part1:Generalrequirements
VI‐10QW
UserManual
Pleasereadtheinstructionscarefullybeforeuse

1D
TABLEOFCONTENT
1. SafetyInstructions.........................................................................................................................2
2. Features.........................................................................................................................................3
3. TechnicalSpecifications.................................................................................................................3
4. Installation....................................................................................................................................4
5. LumenOutput...............................................................................................................................6
6. HowToControlTheFixture...........................................................................................................9
7. DMX512Configuration..................................................................................................................9
8. Troubleshooting..........................................................................................................................10
8. CleaningAndMaintenance.........................................................................................................10
10D
8. Troubleshooting
Ifthefixturedoesnotwork,nolight,pleasechecktheconnectionofpowercableandsignalline,
alsomeasurethemainsvoltageonthemainconnector.
8. CleaningAndMaintenance
Thecleaningmustbecarriedoutperiodicallytooptimizelightoutput.Cleaningfrequencydepends
ontheenvironmentinwhichthefixtureoperates:moist,smokyorparticularlydirtysurrounding
cancausegreateraccumulationofdirtonthefixture.
Cleanwithlint‐freeclothusingnormalglasscleaningliquid.
Alwaysdrythepartscarefully.
Cleanthesurfaceatleastevery30days.

9D
6. HowToControlTheFixture
PleaseoperatethefixturebyVD‐T(soldseparately).VD‐Tisaspeciallydesignedhandysetuptool
forallVisiointegralfixturesandcontrollers.ByconnectingVD‐TtoanyfixtureviaXLR,youcan
easilysetupDMXAddress,ChannelModes,WhiteBalance,ManualColors,andFadeSpeed
functions.IfyouuseVD‐Ttocontrolthefixture,youcanfollowUserManualofVD‐T.
7. DMX512Configuration
2D
1. SafetyInstructions
WARNING
PleasekeepthisUserGuideforfutureconsultation.Ifyousellthefixturetoanotheruser,be
surethattheyalsoreceivethisinstructionbooklet.
Cautions：
Allfixturesareintactfromthemanufacturer,pleaseoperatefollowuptheusermanual,
artificialfaultarenotunderguaranteerepair.
Unpackandcheckcarefullythereisnotransportationdamagebeforeusingthefixture.
Doinstallandoperatebyoperator.
Usesafetychainwhenfixesthefixture.
Besurethatnoventilationslotsareblocked,otherwisethefixturewillbeoverheated.
Beforeoperating,ensurethatthevoltageandfrequencyofpowersupplymatchthepower
requirementsofthefixture.
It’simportanttothegroundwithyellow/greenconductortoearthinordertoavoidelectric
shock.
Maximumambienttemperatureis40℃.Don’toperateitwherethetemperatureishigherthan
this.
Don’tconnectthedevicetoanydimmerpack.
Firstrun,therewillbesmokeorsmells,andalldisappearingafewminuteslater.
Makesuretherearenoflammablematerialsclosetothefixturewhileoperating,asitisfire
hazard.
Lookoverpowerwirescarefully,replaceimmediatelyifthereisanydamage.
Fixturesurfacetemperaturemayreachupto65℃.Don’ttouchthehousingbare‐handduring
itsoperation.
Neverrunonforalongtimelestshorteninglifespan.
Avoidanyinflammableliquids,waterormetalobjectsenteringthefixture.Onceithappen,cut
offthemainspowerimmediately.
Donotoperateindirtyanddustyenvironment,alsocleaningfixturesregularly.
Donotallowchildrentooperatethefixture.
Donottouchanywireduringoperationastheremightbeahazardofelectricshock.
Pleasereadtheinstructionscarefullywhichincludesimportant
informationabouttheinstallation,operationandmaintenance.

3D
Avoidpowerwirestogetheraroundingothercables.
Replacefuseonlywiththesametype.
Intheeventofseriousoperatingproblem,stopusingthefixtureimmediately.
Neverturnonandoffthefixturetimeaftertime.
Thehousing,thelenses,ortheultravioletfiltermustbereplacediftheyarevisiblydamaged.
Donotopenthefixtureastherearenouserserviceablepartsinside.Nevertrytorepairthe
fixturebyyourself.Repairscarriedoutbyunskilledpeoplecanleadtodamageormalfunction.
Pleasecontactthenearestauthorizedtechnicalassistancecenter.
Disconnectthemainspowerifthefixtureisnotusedforalongtime.
Douseoriginalpackingmaterialsoncetransportitagain.
DonotlookdirectlyattheLEDlightbeamwhilethefixtureison.
Toprotectthemachine,poweroff10srearcanelectrify.

2.Features
VIngroundisahighpowerandrobustoutdoorluminaries.WithcuttingedgeLEDtechnology,IP67
ratedanddriveoverresistantconstruction,the
VIngroundisspeciallydesignedforilluminatingwalkways,landscape.

316LStainlesssteeltopcover,diecasthousingandplasticsleeve.
Optimalthermalmanagement.
Easyinstallationandmaintenance.
Excellentperformance,reliabilityandlonglifespan.

3.TechnicalSpecifications
InputVoltage:DC24V
PowerConsumption:14W
LEDs:1X10WCREEQuad‐colorLED
IP:67
BeamAngle:10°,20°,30°
Dimension:φ120X133mm
Weight:0.8Kgs
8D
Lumens:255.789lm
Efficacy:14.29lm/W
BeamAngle:30°
LuminousIntensityDistributionZonalFluxDiagram
 
LuminanceAtDistance
Fluxoutput:118.5lm

Average Beam Angle(50%)
Note: The Curves indicate the illuminated area and the average
illumination when the luminaire is at different distance


7D
Lumens:263.372lm
Efficacy:13.30lm/W
BeamAngle:20°
4D
4. Installation
4.1Beforeinstallthefixture,pleaseensurethepowerisoff.
4.1.1Choosetheappropriatelocationandsecuretheembeddedfittings(plasticsleeve)tothe
location,thenconnectpowercableandsignalline,finallyplacethealuminumbarrelintoit.
P
o
w
e
r
cab
l
e
Signal line

4.1.2RunpowercableandDMXsignallinetojunctionbox(soldseparately),therearetwocolors
redandblackforpowercable,redcableispositive,blackcableisgrounding.Threecolorsred,
whiteandblackforsignalline,redlineis(+),whitelineis(‐)andblacklineisgrounding.
4.1.3Connectwirestothemainspowerorsignalcablesthroughwirenutsorwiringterminalper
codeinstruction.Fordamporwetlocations,useanIPratedjunctionbox,permanufacturer’s
instructions.
4.2ChangeBeamAngle
Ifyouwanttochangebeamangleoffixture,youcanchangelensofthefixturerefertothephoto
below:
Completedbyqualifiedtechnicianonly.

5D
4.3ConnectionDiagram
6D
5. LumenOutput
Lumens:299.35lm
Efficacy:20.65lm/W
BeamAngle:10°