Anova Perforated Steel Café Chair D1145 User manual

anovafurnishings.com
888.535.5005 tel
TOOLS NEEDED:
• Rubber mallet
• Flat head screwdriver
• Ratchet with 1/2" socket
•Level
Assembly Instructions
Streetside Square Café Chairs
D1145 - Perforated Steel Café Chair
F1145 - Expanded Steel Café Chair
CHAIR COMPONENTS:
ASSEMBLY HARDWARE: All hardware is stainless steel.
(1) Contour Seat
Streetside Expanded Steel
Café Chair
Streetside Perforated Steel
Café Chair
(2) Seat Supports (2) Spacers
ASSEMBLY:
Inspect the shipping container contents for damage and to
determine that all components and hardware are present.
1.
2. Assemble the chair over the shipping packaging or padded
work area to avoid scratching the product.
NOTE: Before assembling the nuts to the bolts, it is
recommended that a light oil or petroleum jelly be applied
to the screw threads.
1
(6) 5/16"-18 x 2"
Slotted Screws
(6) 5/16"-18
Nylock Nuts
(6) 5/16" Flat Washers (4) Foot
3. Locate the contour seat and place it on the work surface as
shown.
NOTE: Installing the screw in this direction reduces the
risk of scratching during use.
Align one of the spacers on the edge of the seat so the
mounting holes line up.
Align one of the supports over the spacer so the mounting
holes line up. Then insert three 2" screws through all three
parts with the screw head on the outside of the chair. Place
a at washer and nylock nut on the end of each screw and
tighten nger tight.
5/16"-18 x 2"
Slotted Screw
Seat Support
Spacer
5/16" Flat Washer
5/16"-18
Nylock Nut
Contour Seat

01/26/2018 Copyright 2018 ANOVA® Made in USA. 2
Note: Please contact Customer Care at 1-866-797-1761 when ordering replacement parts.
4.
5.
6.
7.
Repeat Step 3 on the opposite side to install the remaining support assembly.
Turn the chair upright and partially insert the four plastic feet into the bottom of each support leg. Allow the chair to rest on the feet
and adjust the feet so they rest at. When they are positioned correctly, turn the chair upside down and set each of the feet into the
leg with a rubber mallet.
Tighten the hardware while checking the seat with a level.
Aer two weeks, retighten all of the hardware.
Note: Use the at head screwdriver to keep the screw
head stationary while tightening the nylock nut. This will
protect the coating on the screw.
Foot
Assembly and Replacement Parts
Spacer
Seat Support
Contour Seat