Ballard Designs Daphne SF055 User manual

PRODUCTS ARE NOT INTENDED
FOR COMMERCIAL USE.
UPDATED: March 2019 Page 1 of 3
PRODUCT NAME: Daphne Sideboard
ITEM NUMBER: SF055
ASSEMBLED DIMENSIONS :35”H x 60”W x 17.76”D
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
MADE IN CHINA

Customer Service: 800-367-2810
Online: www.ballarddesigns.com Page 2 of 3
Ltr.
A 8
B 2
Qty. Hardware Included
Ltr.
D
E
1
1
Qty. Components
C 1
TOOLS NEEDED:
-Phillips Screwdriver
-Two person assembly suggested.
Remove all parts, hardware and
protective packaging from carton
and carefully arrange on a clean,
level, padded surface.
NOTE: To avoid accidentally
discarding small parts or hardware,
retain all carton contents until
assembly and installation are complete.
Shelf Support
Anti-Tip Kit
Console (C)
Shelf D
Shelf E
D
E
D
&
E
A
*LEVELERS
*Console equipped with Levelers
on each corner. Gently turn clock-
wise/counterclockwise to adjust
console to level. NOTE: If doors
are uneven, adjust levelers until
aligned.
STEP 1: Determine location for each Shelf (D, E) then insert Shelf Supports (A) into corresponding
pre-drilled holes. Gently position each shelf to rest upon pad on Shelf Support.

Page 3 of 3
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
ANTI TIP INSTALLATION: PART B
Ltr. Qty. Hardware Included
F 2
G 2
H 4
I 2
Small Screw
Large Screw
Brackets
Retention Belt
C
Cleaning & Care:
DO NOT use alcohol based products or spray polisher as finish damage may result.
Dust with a soft cloth.
Serious or fatal crushing injuries can occur from a furniture tip-over
WARNING
Tip-Over Hazard
WALL BRACKET MUST BE ATTACHED TO WALL STUD
Prevent tipping accidents. Anchor your furniture.
1. Locate and mark a Wall Stud behind Console at location for installation.
2. Corresponding to Stud location, attach one Bracket (H) to back of Console using Small Screw (F).
3. To keep hardware out of view after installation, attach remaining Bracket (H) INTO WALL STUD
with Large Screw (G) 2 inches below Bracket attached to back of Console.
4. Move Console into place, align Brackets then connect both using Retention Belt (I).
5. Confirm Strap is securely laced and locked.
Anti-Tip Hardware Installation
(F) (I)
(H)
(H)
(G)
Wall Stud