Ballard Designs WE026 User manual

Prevent accidentally discarding small parts or
hardware. Retain all carton contents until assembly
and installation are complete.
PRODUCTS ARE NOT INTENDED
FOR COMMERCIAL USE.
UPDATED: 6-3-2021 Page 1 of 5
PRODUCT NAME: Gallery Wall System
ITEM NUMBER: WE026
ASSEMBLED DIMENSIONS : 73 1/2”H x 64”W x 1 1/4”D
MADE IN INDIA
Customer Service: 800-367-2810
Online: www.ballarddesigns.com

Page 2 of 5
Ltr.
A2
B 2
Qty. Hardware Included
Ltr.
D
E
2
8
Qty. Components
C1
REQUIRED TOOLS:
Phillips Screwdriver, Small Hammer,
Level, Pencil
Remove all parts, hardware and
protective packaging from carton
and carefully arrange on a clean,
level, padded surface.
Screws
Wall Anchors
F
G
24
8
Rod (C)
Finials (D)
Rod Hooks (E)
Chain Hooks (F)
Chains (G)
Maximum support provided when one Bracket is centered on a Wall Stud.
ASSEMBLY AND INSTALLATION
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
5

Page 3 of 5
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
Use Wall Anchors in open drywall. Do not use when wall stud is present.
Mark location. Use pointed tool to make
a very small pilot hole.
Gently tap tip of Anchor into pilot hole
then use a screwdriver and turn it in until
flush with wall surface.
Add item/Align holes. Add/tighten screw.
INSTALLING SCREW-TYPE WALL ANCHORS
1
3
2
Fig. 3
(C)
STEP 2: Carefully lift Wall Bracket (C) to Screw heads and push/pull down to lock in place.
For maximum support, at least one hole should
be centered on a WALL STUD.
INSTALLATION TIP
Use Wall Anchors in open drywall. Do not use when wall stud is present.
SCREW

Cleaning and Care
Periodically dust with a soft, dry cloth.
Protect surfaces to prevent damage.
Do not use alchohol based cleaners or polishers.
Page 4 of 5
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
STEP 3: Finial(s) (D) must be removed from Rod (C) before Rod Hooks (E) may be added. Orient
each Rod Hook as illustrated and gently slide toward center of Rod. Replace Finial(s) when complete.
NOTE: Remove and install Finial by gently pulling out or pushing in.
(D)
(D)
(C)
(C)
(E)
STEP 4: Carefully hang each Chain (G) from each Rod Hook (E). Use Chain Hooks (F) as
needed/required for display.
N
O
T
E
Chain length may be adjusted by using pliers to gently open and remove links.
(G)
(F)
(E)

Page 5 of 5
1Place a strip of Painter’s Tape over both Keyholes on back of item to be hung.
PAINTER’S TAPE
Use a Screwdriver or other pointed tool to punch a hole in tape at TOP of each Keyhole.
2
Use a Level and Pencil to mark wall at installation location.
3
How to Create a Template for Keyhole Brackets
TOP
OF KEYHOLE
Remove Tape from back of item, place on wall at level line and mark location of punches.
Remove Tape and follow instructions for creating holes and installing specific hardware.
4
PAINTER’S TAPE
P
A
I
N
T
E
R
’
S
T
A
P
E