Ballard Designs MQ124 MPS RGT User manual

REQUIRED TOOLS:
Phillips Screwdriver, Allen Wrench (included)
-Two person assembly suggested.
Ltr.
A
Qty. Hardware/Components Included
Wall Anchoring
(Anti-tip) Kit
See page 2
B
C
Cabinet (B)
Shelf (A)
Installed inside Cabinet
includes 4 shelf supports
2
1
1
PRODUCTS ARE NOT INTENDED
FOR COMMERCIAL USE.
UPDATED: 11-2-2021 Page 1 of 2
PRODUCT NAME: Grove *Cabinet (RIGHT)
ITEM NUMBER: MQ124 MPS RGT
ASSEMBLED DIMENSIONS : 50”H x 18”W x 18”D
MADE IN INDONESIA
(A)
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
ADJUSTABLE SHELF: Shelf (A) ships pre-installed
inside Cabinet. May be height adjusted by lifting out then
removing and relocating each Shelf Support. Replace
shelf by carefully setting level upon supports.
LEVELERS:Cabinet is equipped with
Rotary Levelers installed under each corner.
If necessary, adjustments may be made by
carefully lifting applicable corner and turning
Leveler clockwise/counterclockwise.
* Designed for use with Grove Console and/or
Hutches (MQ125/MQ123) which are
SOLD SEPARATELY.

WALL BRACKET MUST BE ATTACHED TO WALL STUD
WALL ANCHORING HARDWARE (ANTI-TIP)
Serious or fatal crushing injuries can occur from a furniture tip-over
Tip-Over Hazard
Prevent tipping accidents. Anchor your furniture.
WARNING
Ltr.
A4 Small Screw
Retention Belt
Qty. Hardware Included
B4 Large Screw
C4 Bracket
D2
1. Place furniture against wall at desired location then locate and mark a Wall Stud behind unit.
2. Corresponding to Stud location, attach one Bracket (C) to back of unit using Small Screws (A).
3. To keep hardware out of view after installation, attach remaining Bracket (C) INTO WALL STUD
with Large Screws (B) 2 inches below Bracket attached to back of unit.
4. Move unit into place, align Brackets then connect both using Retention Belt (D).
5. Confirm Belt is securely laced and locked.
Page 2 of 2
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
Cleaning and Care
Periodically dust with a soft, dry cloth.
Prevent finish damage: do not use alcohol based
cleaners or polishers. Promptly remove spills.
IF INSTALLING UNIT WITH HUTCH ATTACHED, FOLLOW INSTRUCTIONS INCLUDED WITH HUTCH. ANCHOR AT
TOP OF HUTCH. CABINET DOES NOT NEED TO BE ANCHORED WHEN HUTCHES ARE CONFIGURED.
NOTICE: Installing a Hutch? Hutches must be secured to Cabinet using Connector
Brackets (included with Hutch) before anchoring to wall stud.