Ballard Designs Grace MN037 User manual

Prevent accidentally discarding small parts or
hardware. Retain all carton contents until assembly
and installation are complete.
PRODUCTS ARE NOT INTENDED
FOR COMMERCIAL USE.
UPDATED: 11-16-2020 Page 1 of 3
PRODUCT NAME: Grace Side Table Open Base
ITEM NUMBER: MN037
ASSEMBLED DIMENSIONS : 29”H x 32”W x 18”D
MADE IN INDONESIA
Customer Service: 800-367-2810
Online: www.ballarddesigns.com

Page 2 of 3
Ltr.
A1
Qty. Hardware Included
Ltr.
B1
Qty. Components
REQUIRED TOOLS:
Phillips Screwdriver
-Two person assembly suggested.
Remove all parts, hardware and
protective packaging from carton
and carefully arrange on a clean,
level, padded surface.
WARNING
Tip-Over Hazard
Prevent tipping accidents. Anchor your furniture.
ANCHORING HARDWARE INCLUDED
Wall Anchoring
(Anti-tip) Hardware Kits
See Page 3
Side Table (B)
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
CHARGING PAD: Qi Wireless Charger works with Qi enabled devices such as Samsung Qi enabled
Smartphones and Apple iPhone 8 or above. No other objects should be placed on pad. Phone case
may impede charging. (Input: 5V/2.4A Output: 5W MAX) NOTE: Surge Protector recommended.
LEVELERS: Each leg equipped with a Rotary Leveler. Lift applicable corner and turn Leveler to adjust.
LEVELERS
Qi CHARGING PAD
-Plug USB Adapter into outlet.
-Place Qi enabled device over pad.
-Remove device cover if necessary.
Cleaning and Care
Periodically dust with a soft, dry cloth.
Prevent finish damage: do not use alchohol based
cleaners or polishers. Promptly remove spills.
Remove label marker before use.
Assemble in location for intended use.

Page 3 of 3
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
(C)
(B)
(D)
(A)
WALL BRACKET MUST BE ATTACHED TO WALL STUD
WALL STUD
(6 x
34
'')
(6 x1
12
'')
5. Confirm Belt is securely laced and locked.
4. Move unit into place, align Brackets then connect both using Retention Belt (D).
with Large Screws (B) 2 inches below Bracket attached to back of unit.
3. To keep hardware out of view after installation, attach remaining Bracket (C) INTO WALL STUD
2. Corresponding to Stud location, attach one Bracket (C) to back of unit using Small Screws (A).
1. Place furniture against wall at desired location then locate and mark a Wall Stud behind unit.
2
D
Bracket4
C
Large Screw
4B
Hardware Included
Qty.
Retention Belt
Small Screw
4
A
Ltr.
WALL ANCHORING HARDWARE (ANTI-TIP)
Serious or fatal crushing injuries can occur from a furniture tip-over
Tip-Over Hazard
Prevent tipping accidents. Anchor your furniture.
WARNING