Ballard Designs LO477 User manual

PRODUCT NAME: Reza Solar Lantern
ITEM NUMBER: LO477
ASSEMBLED DIMENSIONS: 15” H x 5” W x 5” D or 11”H x 7”W x 7”D
PRODUCTS ARE NOT INTENDED
FOR COMMERCIAL USE. Page 1 of 2
MADE IN CHINA
IMPORTANT SAFETY INSTRUCTIONS:
-For your safety, read entire Instruction Sheet before using lamp.
-Keep product out of reach of children.
-Do not leave lamp outside in heavy rain. Protect from excessive moisture.
-Charge lamp in direct sunlight.
-Do not drop or place heavy objects on lamp.
-Do not use lamp if cracked or broken.
WARNING:
-Replace battery with RECHARGEABLE 3.2v 600mAh 14500 Lithium-ion battery.
-Do not use non-rechargeable batteries.
-Do not immerse lamp in water.
-Do not dispose lamp into trash. Refer to local regulations for proper disposal.
-Battery should be fully discharged before disposal.
-Remove battery during long periods of storage.
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
Retain these instructions for future reference.

NOTE: Remove all parts from box along with any plastic
protective packaging and carefully lay all parts.
DO NOT discard any packaging until assembly and
installation are complete.
Approved Location for Use: Indoor/Outdoor Environment
Charging Time: Approximately 8 hours via direct sunlight
Running Time: Approximately 6 hours
COMPONENTS
Check to make sure you have the following:
INCLUDED:
Page 2 of 2
1- Lamp
(Rechargeable battery installed)
ENVIRONMENTAL PROTECTION:
This symbol on the product dictates that Waste electrical products should not be disposed of
with household waste. Please recycle where facilities exist. Check with your Local Authority or
retailer for recycling advice.
STEP 1: Fully charge battery by placing Lamp in direct sunlight for at least 8 hours.
CLEANING and CARE: Periodically wipe down with a soft, clean cloth. Turn off when not in use.
BATTERY: - Battery compartment located under solar panel. Remove panel from lamp.
- Open battery compartment by removing screws.
- Replace with 3.2v 600 mAh 14500 Lithium-ion RECHARGEABLE battery.
- Correctly orient battery to polarity marks (+/-).
- Replace cover, tighten screws then place compartment into lamp along with solar panel.
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
Retain these instructions for future reference.