Ballard Designs Gentilly WV007 User manual

Prevent accidentally discarding small parts or
hardware. Retain all carton contents until assembly
and installation are complete.
PRODUCTS ARE NOT INTENDED
FOR COMMERCIAL USE.
UPDATED: 9-28-2020 Page 1 of 4
PRODUCT NAME: Gentilly Decorative Shelf
ITEM NUMBER: WV007
ASSEMBLED DIMENSIONS : 30”H x 30”W x 8”D
MADE IN CHINA
Customer Service: 800-367-2810
Online: www.ballarddesigns.com

Page 2 of 4
REQUIRED TOOLS:
Phillips Screwdriver, Pencil, Level,
Drill with 3/8” bit
-Two person assembly suggested.
Remove all parts, hardware and
protective packaging from carton
and carefully arrange on a clean,
level, padded surface.
WARNING
Falling Hazard
WALL SHELF MUST BE ADEQUATELY SUPPORTED
AT LEAST ONE SCREW SHOULD BE DRIVEN INTO A WALL STUD
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
Ltr.
A 2
B 1
Qty. Hardware Included
Ltr.
C1
Qty. Components
Screws
M4 x 40mm
Expansion Bolt
M5 x 52mm
Wall Shelf (C)
Hardware
Packet
Cleaning and Care
Periodically dust with a soft, dry cloth.
Prevent finish damage: do not use alchohol based
cleaners or polishers.
STEP 1: Determine location for Shelf (C) then use a level and pencil to mark wall (Fig. 1).
TIP: See Page 4 for creating an easy Keyhole Template.
NOTE: Maximum support is provided when at least one Screw (A) is anchored directly into a wall
stud. For location where no wall stud is present, use Expansion Bolt (B) (Fig. 2 Page 3)
Fig. 1
WALL
STUD
Optimal support is provided when Wall Decor
is anchored directly into a Wall Stud.
Keyholes on back of
Shelf are 28.6” apart.
Assemble in location for intended use.

Page 3 of 4
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
Drywall
3/8” Drill Bit
(B)
Teeth
(B)
Barrel
Create Pilot Hole Tap in Bolt until teeth sink into wall surface.
Turn screw clockwise until it begins to slip. Back out approximately 1/4 inch.
12
34
INSTALLING EXPANSION BOLTS
Fig. 2
(A) (B)
or
(C) (C)
STEP 2: Carefully lift Shelf (C) and fit Keyhole over Screw/Bolt Heads then pull/push down to lock.

Page 4 of 4
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
1Place a strip of Painter’s Tape over both Keyholes on back of item to be hung.
PAINTER’S TAPE
Use a Screwdriver or other pointed tool to punch a hole in tape at TOP of each Keyhole.
2
Use a Level and Pencil to mark wall at installation location.
3
How to Create a Template for Keyhole Brackets
TOP
OF KEYHOLE
Remove Tape from back of item, place on wall at level line and mark location of punches.
Remove Tape and follow instructions for creating holes and installing specific hardware.
4
PAINTER’S TAPE
P
A
I
N
T
E
R
’
S
T
A
P
E