Ballard Designs MS136 User manual

REQUIRED TOOLS:
Phillips Screwdriver, Flat Blade Screwdriver (levelers)
-Two person installation suggested.
Ltr.
A2
B8
Qty. Hardware/Components Included
Wall Anchoring
(Anti-tip) Kits
See page 3
Serious or fatal crushing injuries can occur from a furniture tip-over
Tip-Over Hazard
Prevent tipping accidents. Anchor your furniture.
WARNING
ANCHORING HARDWARE INCLUDED
C4
D2
E1
PRODUCTS ARE NOT INTENDED
FOR COMMERCIAL USE.
UPDATED: 11-8-2021 Page 1 of 3
PRODUCT NAME: Enzo Console
ITEM NUMBER: MS136
ASSEMBLED DIMENSIONS : 36.5”H x 75”W x 15”D
MADE IN CHINA
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
Shelf Supports
Shelves
Wooden Plugs
Console

Cleaning and Care
Periodically dust with a soft, dry cloth.
Prevent finish damage: do not use alcohol based
cleaners or polishers. Promptly remove spills.
Page 2 of 3
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
SHELVES: Determine location for each adjustable Shelf (D) then insert Shelf Supports (B) into corre-
sponding pre-drilled holes. Set Shelf level upon Supports.
Assemble in location for intended use.
(B)
(D)
LEVELERS: Console (E) is equipped with Rotary Levelers under each corner which are accessible from
INSIDE Console. 1. Insert screwdriver through hole in corner, adjust Leveler by turning clockwise/coun-
terclockwise. 2. Cover hole with Wooden Plug (C)
1
2

Page 3 of 3
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
Installation:
Ltr.
A2
Small Screw
Retention Belt
Qty. Hardware Included
B2
Large Screw
C4 Bracket
D2
WALL ANCHORING HARDWARE (ANTI-TIP)
1. Place furniture against wall at desired location then locate and mark a Wall Stud behind unit.
2. Corresponding to Stud location, attach one Bracket (C) to back of unit using Small Screw (B).
3. To keep hardware out of view after installation, attach remaining Bracket (C) INTO WALL STUD
with Large Screw (A) 2 inches below Bracket attached to back of unit.
4. Move unit into place, align Brackets then connect both using Retention Belt (D).
5. Confirm Belt is securely laced and locked.
Serious or fatal crushing injuries can occur from a furniture tip-over
Tip-Over Hazard
Prevent tipping accidents. Anchor your furniture.
WARNING
W
A
L
L
S
TUD
WALL BRACKET MUST BE ATTACHED TO WALL STUD
(A)
(B)
(C)
(D)
Representative Image
Not meant to be actual item included with
these instructions.