Ballard Designs WS996 User manual

PRODUCTS ARE NOT INTENDED
FOR COMMERCIAL USE.
UPDATED: 4-1-2020 Page 1 of 4
PRODUCT NAME: Mini Beadboard Drying Rack
ITEM NUMBER: WS996
ASSEMBLED DIMENSIONS : 7 1/4”H x 23”W x 2 1/2”D
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
MADE IN CHINA

Customer Service: 800-367-2810
Online: www.ballarddesigns.com Page 2 of 4
Ltr.
A 2
B2
Qty. Hardware Included
Ltr.
1
1
Qty. Components
C
REQUIRED TOOLS:
Phillips Screwdriver, Level,
Pencil, Drill with 3/8” bit
-Two person assembly suggested.
Remove all parts, hardware and
protective packaging from carton
and carefully arrange on a clean,
level, padded surface.
NOTE: To avoid accidentally
discarding small parts or hardware,
retain all carton contents until
assembly and installation are complete.
Screws
Expansion Bolts
D
HARDWARE
Wall Decor is HEAVY and requires adequate support.
Falling Hazard
Wall Brackets must be firmly attached to WALL STUDS.
WARNING
Drying Rack (C)
Wall Bracket (D)
Assemble in location for intended use.

Page 3 of 4
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
STEP 1: Determine location for Drying Rack and locate at least two WALL STUDS in wall behind it.
Use a level to position Wall Bracket (D) and center a hole over each WALL STUD. Insert and drive
Screw (A) directly into WALL STUD. For holes located in open drywall (no stud) use an Expansion
Bolt (B). See Step 2 for installation instructions.
WALL BRACKET MUST BE ATTACHED TO WALL STUD
(D)
(B)
(A)
STEP 2: For Bracket hole locations where no wall stud is present, mark location and use a drill with a
3/8” bit to create a pilot hole. Lightly tap Expansion Bolt (B) into hole and sink teeth into wall surface.
Drywall
3/8” Drill Bit
(B)
Teeth

Page 4 of 4
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
Cleaning & Care:
DO NOT use alcohol based products or spray polisher as
they can damage the finish. Dust with soft cloth.
STEP 3: Use a screwdriver to press down and firmly turn screw clockwise until it begins to slip indi-
cating the barrel has crimped against inside of drywall. Back out and completely remove Screw,
leaving bolt/anchor in wall. Position Bracket (D), align holes, replace and tighten Screw.
Barrel
Turn screw until it slips Remove screw
STEP 4: With Bracket (D) firmly attached to wall, carefully lift Drying Rack (C) and engage cleat on
back with Bracket as illustrated below. Gently push/pull down until Rack is fully seated and locked in
place.
B
ac
k
o
f
R
a
c
k
(D)
(C)