Ballard Designs Casa Florentina MO646 User manual

PRODUCT NAME: CF Lamberti Desk
ITEM NUMBER: MO646
ASSEMBLED DIMENSIONS: 37”H x 24.5”W x 14”D
PRODUCT NOT INTENDED
FOR COMMERCIAL USE.
UPDATED: 3-6-2023
MADE IN ITALY
Page 1 of 4
Customer Service: 800-367-2810
Online: www.ballarddesigns.com

Page 2 of 4
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
Ltr.
A 8
B 2
Qty. Hardware Included
Ltr.
D4
Qty. Components
C1
REQUIRED TOOLS:
Phillips Screwdriver
-Two person assembly suggested.
Remove all parts, hardware and
protective packaging from carton
and carefully arrange on a clean,
level, padded surface.
Bolts
Wall Anchoring
(Anti-tip) Hardware
See Page 4
Serious or fatal crushing injuries can occur from a furniture tip-over
Tip-Over Hazard
Prevent tipping accidents. Anchor your furniture.
WARNING
ANCHORING HARDWARE INCLUDED
Desk (C)
Legs (D)
Cleaning and Care
Periodically dust with a soft, dry cloth.
Prevent finish damage: do not use alchohol based
cleaners or polishers. Promptly remove spills.
Assemble in location for intended use.

Page 3 of 4
(A)
(C)
(D)
STEP 1: Lay Desk (C) back down onto a level, padded surface. Fit a Leg (D) into each corner, aligning
holes in Metal Bracket with both holes in Leg. Insert, turn and tighten two Bolts (A) using a Screwdriver.
Assemble in location for intended use.
CAUTION: Do not palce uneven pressure on Legs as Desk is turned upright.
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
LEVELERS: Legs are equipped with Rotary
Levelers installed under each. If necessary,
adjustments may be made by turning Leveler
clockwise/counterclockwise.
STEP 2: Move assembled desk into place and level as necessary. Level unit BEFORE anchoring to
wall.

Installation:
Ltr.
A2
Small Screw
Retention Belt
Qty. Hardware Included
B2
Large Screw
C4 Bracket
D2
WALL ANCHORING HARDWARE (ANTI-TIP)
1. Place furniture against wall at desired location then locate and mark a Wall Stud behind unit.
2. Corresponding to Stud location, attach one Bracket (C) to back of unit using Small Screw (B).
3. To keep hardware out of view after installation, attach remaining Bracket (C) INTO WALL STUD
with Large Screw (A) 2 inches below Bracket attached to back of unit.
4. Move unit into place, align Brackets then connect both using Retention Belt (D).
5. Confirm Belt is securely laced and locked.
Serious or fatal crushing injuries can occur from a furniture tip-over
Tip-Over Hazard
Prevent tipping accidents. Anchor your furniture.
WARNING
W
A
L
L
S
TUD
WALL BRACKET MUST BE ATTACHED TO WALL STUD
(A)
(B)
(C)
(D)
Page 4 of 4
Representative Image
Not meant to be actual item included with
these instructions.