Ballard Designs Paulette Hutch SK014 User manual

PRODUCT NAME: Paulette Hutch
ITEM NUMBER: SK014
DIMENSIONS OF ITEM ASSEMBLED: 48”H X 28”W X 12”D
PRODUCTS ARE NOT INTENDED
FOR COMMERCIAL USE.
UPDATED: 3-2-2020 Page 1 of 4
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
MADE IN CHINA

Customer Service: 800-367-2810
Online: www.ballarddesigns.com Page 2 of 4
Hardware Included
Shelf Supports
Ltr.
A
Ltr.
Qty.
8
Connector Plates
B 2
D 2
Screws
C 8
F1
G
Qty. Components
Shelves (E)
Plate Groove
E 2
Hutch (F)
Item No. SK014
Wall Anchoring
(Anti-tip) Kits
See page 4
Assemble in location for intended use.
REQUIRED TOOLS:
- Phillips Screwdriver
-Two person assembly suggested.
Remove all parts, hardware and
protective packaging from carton
and carefully arrange on a clean,
level, padded surface.
NOTE: To avoid accidentally
discarding small parts or hardware,
retain all carton contents until
assembly and installation are complete.
WARNING
Tip-Over Hazard
Prevent tipping accidents. Anchor your furniture.
ANCHORING HARDWARE INCLUDED
*Drawer Console (G)
Item No. SK015
*Cabinet (G)
Item No. SK032
*Shelf Console (G)
Item No. SK051
*Base type and configuration is optional
*

Page 3 of 4
STEP 2: Set Hutch (F) on top of Base (G), align as illustrated then position and attach both
Connector Plates (B) using Screws (C). WARNING: To prevent a dangerous tip-over
accident, Hutch and Base MUST be securely attached using Connector Plates.
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
(F)
(F)
(F)
(C) (B)
*(G)
(G)
(E)
(A)
STEP 1: Determine location for each Shelf (E) the insert Shelf Supports (A) into pre-drilled holes.
Carefully place Shelf upon Supports with Plate Groove toward back of Hutch.
*Base type and configuration is optional.
Assemble in location for intended use.

Page 4 of 4
Installation:
Cleaning & Care:
DO NOT use alcohol based products or spray polisher as
they can damage the finish. Dust with soft cloth.
Ltr.
A2
Small Screw
Retention Belt
Qty. Hardware Included
B2
Large Screw
C4 Bracket
D2
WALL ANCHORING HARDWARE (ANTI-TIP)
1. Place furniture against wall at desired location then locate and mark a Wall Stud behind unit.
2. Corresponding to Stud location, attach one Bracket (C) to back of unit using Small Screw (B).
3. To keep hardware out of view after installation, attach remaining Bracket (C) INTO WALL STUD
with Large Screw (A) 2 inches below Bracket attached to back of unit.
4. Move unit into place, align Brackets then connect both using Retention Belt (D).
5. Confirm Belt is securely laced and locked.
Serious or fatal crushing injuries can occur from a furniture tip-over
Tip-Over Hazard
Prevent tipping accidents. Anchor your furniture.
WARNING
W
A
L
L
S
TUD
WALL BRACKET MUST BE ATTACHED TO WALL STUD
(A)
(B)
(C)
(D)
R
e
presen
t
a
tiv
e
Fu
r
nitu
r
e
I
tem