Ballard Designs Amalfi JC003 User manual

PRODUCT NAME: Amalfi 48 Inch Round Dining Table
ITEM NUMBER: JC003
DIMENSIONS OF ITEM ASSEMBLED: 29 1/4”H x 48”Diam.
UPDATED: 9/25/2013
PRODUCTS ARE NOT INTENDED
FOR COMMERCIAL USE. Page 1 of 4
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
MADE IN CHINA

Customer Service: 800-367-2810
Online: www.ballarddesigns.com Page 2 of 4
TOOLS NEEDED:
-Assembly requires 2 or more people.
-Wrench required.
NOTE: The Table comes with
an Umbrella Hole Cover (J) if you
choose to use it.
Ltr.
A 4 Headless Bolts
B 12 Washers
C 12 Lock Washers
Table Top (F)
Center Plates (G)
Center Plates (G)
Parts Bag
Located Here
(A-E, I & J)
Table Top (F)
Table Legs (H)
Table Legs (H)
D 12 Nuts
E 12 Nut Caps
Qty. Hardware Included
Ltr.
F
G
1
4
H 4
I 1
J 1
Qty. Components
Umbrella Ring (I)
Umbrella Hole Cover (J)

Page 3 of 4
WARNING: Aluminum is a soft metal and over-tightening will strip the thread or break the part.
STEP 1: Turn the Table Top (F) upside down on a smooth, clean surface. Loosely attach the
Table Legs (H) to the Table Top (F) using the Headless Bolts (A), Washers (B),
Lock Washers (C) and Nuts (D). Leave Nuts loose enough for the assembly of the
Center Plates (G).
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
STEP 2: Thread and overlap all four of the Center Plates (G) onto the Table Legs. Loosely attach
the Center Plates (G) and Table Legs (H) by screwing in the Washers (B), Lock Washers (C)
and Nuts (D) from the inside of the overlapping Center Plates. Tighten all the Nuts (D) and
slide the Nut Caps (E) onto each end.
(H)
(H)
(G)
(G)
(F)
(F)
(H)
(D)
(D)
(C)
(C)
(B)
(B)
(A)

STEP 3: Turn the Table upright. If the Table is uneven, adjust the levelers on the bottom of each
Leg (H) by twisting them clockwise or counterclockwise until the Table is even. Insert the
Umbrella Ring (I) if the hole is too large for your umbrella pole. Use the
Umbrella Hole Cover (J) to cover the hole in the Table Top (F) by inserting it into the hole.
Page 4 of 4
IMPORTANT:
Aluminum is soft metal and overtightening will strip the thread or
break the part.
Please do not use acid or alkaline washing liquid to clean this item.
Cleaning & Care:
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
WARNING: Aluminum is a soft metal and over-tightening will strip the thread or break the part.
(I)