Ballard Designs SUZANNE KASLER MO584 User manual

PRODUCT NAME: SK Geneva Faceted Desk
ITEM NUMBER: MO584
ASSEMBLED DIMENSIONS: 31”H x 60”W x 24”D
PRODUCTS ARE NOT INTENDED
FOR COMMERCIAL USE.
UPDATED: 7-9-2020 Page 1 of 4
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
MADE IN CHINA
SUZANNE KASLER
BALLARD DESIGNS

Customer Service: 800-367-2810
Online: www.ballarddesigns.com Page 2 of 4
Assemble in location for intended use.
Prevent accidentally discarding small parts or
hardware. Retain all carton contents until assembly
and installation are complete.
REQUIRED TOOLS:
Phillips Screwdriver,
Allen Wrench (included)
Two person assembly suggested.
Remove all parts, hardware and
protective packaging from carton and
arrange on a clean, level surface.
WARNING
Tip-Over Hazard
Prevent tipping accidents. Anchor your furniture.
ANCHORING HARDWARE INCLUDED
Cleaning and Care
Periodically dust with a soft, dry cloth.
Prevent finish damage: do not use alchohol based
cleaners or polishers. Promply remove spills.

Page 3 of 4
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
STEP 1: Invert Desk Top (G) onto a padded, clean, level surface and fully open both Drawers as
illustrated. Attach both Side Panels (H) using *Bolts (A,B) with Lock Washer (D) and Flat Washer (C).
NOTE: Holes for installing Side Panel Bolts are accessed from inside Drawer compartments.
*PREVENT DAMAGE: INSTALL LONG AND SHORT BOLTS AS ILLUSTRATED!
STEP 2: Desk is equipped with Rotary Levelers under each corner. If necessary, Desk may be adjusted
by carefully tipping applicable corner and turning Leveler clockwise/counterclockwise.

Page 4 of 4
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
Installation:
Ltr.
A2
Small Screw
Retention Belt
Qty. Hardware Included
B2
Large Screw
C4 Bracket
D2
WALL ANCHORING HARDWARE (ANTI-TIP)
1. Place furniture against wall at desired location then locate and mark a Wall Stud behind unit.
2. Corresponding to Stud location, attach one Bracket (C) to back of unit using Small Screw (B).
3. To keep hardware out of view after installation, attach remaining Bracket (C) INTO WALL STUD
with Large Screw (A) 2 inches below Bracket attached to back of unit.
4. Move unit into place, align Brackets then connect both using Retention Belt (D).
5. Confirm Belt is securely laced and locked.
Serious or fatal crushing injuries can occur from a furniture tip-over
Tip-Over Hazard
Prevent tipping accidents. Anchor your furniture.
WARNING
W
A
L
L
S
TUD
WALL BRACKET MUST BE ATTACHED TO WALL STUD
(A)
(B)
(C)
(D)
R
e
presen
t
a
tiv
e
Fu
r
nitu
r
e
I
tem