Ballard Designs Saratoga SL074 User manual

PRODUCTS ARE NOT INTENDED
FOR COMMERCIAL USE.
UPDATED: 12/9/2016 Page 1 of 4
PRODUCT NAME: Saratoga Extension Dining Table
ITEM NUMBER: SL074
DIMENSIONS OF ITEM ASSEMBLED: 30”H x 84”W x 36”D
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
MADE IN CHINA

Customer Service: 800-367-2810
Online: www.ballarddesigns.com Page 2 of 4
Ltr.
A 8
B
Allen Bolts
Lock Washers
Flat Washers
Allen Wrench8
Qty. Ltr.
C 8
D 1
Qty.Hardware Included
Ltr.
E
Table Top (E)
Legs (F)
1
Qty. Components
F 4
NOTE: When unpacking, lay the parts on a padded
surface such as the packaging provided. Be sure to
locate all hardware before throwing away
any packaging.
TOOLS NEEDED:
-Requires a screwdriver.
-Two person assembly required.
NOTE: Assemble the Table in desired location for use.
Box 1
F- 2 PCS
Box 2
F- 2 PCS
Hardware located
here (A-D)

Page 3 of 4
STEP 1: Lay the Table Top (E) upside down on a smooth clean surface, such as the packaging
provided. Using a Phillips head screwdriver, remove the screws and protective wood from
the Table sides.
Insert the Legs (F) into each corner of the Table Top (E). Use an Allen Bolt (A), Lock
Washer (B) and Flat Washer (C) to secure the Leg in place by tightening the Bolt with the
Allen Wrench (D).
STEP 2:
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
(A)
(B)
(E)
(E)
(F)
NOTE: Assemble the Table in desired location for use.
(D)
(C)

Page 4 of 4
STEP 3:
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
Turn the Table upright. If the Table is uneven, adjust the Levelers located on the bottom of
the Legs (F). Carefully elevate one side of the Table and twist the Levelers clockwise and
counterclockwise until the Table sits evenly.
Clean & Care:
DO NOT use alcohol based products or spray polisher as
they can damage the finish. Dust with a soft cloth.
(F)
NOTE: Assemble the Table in desired location for use.
STEP 4: Unlock the Table Top (E) and pull it apart to insert or remove the Leaf. The lock is
underneath the Table Top. To remove the Leaf, pull the ends apart so that the Leaf can easily
be lifted out. Push the ends together and lock the Top into place. To insert the Leaf, place
it on the guide rails and align the pegs on the Leaf with the holes in the Table Top. Lock the
Leaf in place.
(UNLOCK)