Bay-Tek Willy Crash Manual

6
The game will arrive on one pallet. Please inspect the pallet for
shipping damage and report immediately to the freight company
if any damage is found.
Unbox the pallet and remove the plastic from the top of the
player console. This is the marquee.
Please unwrap the marquee and proceed to assembly instructions.
WILLY CRASH GAME SETUP
Unlock the front door using a H95 key.
Tools Needed:
1 step ladder (4-6 foot) # 2 Square bit
Remove the hardware kit and power cord from the coin
box.
Close and lock coin box door, remove key to allow the
front door to close fully.
Unlock the coin box door using a E00 key.
Remove the keys from the small plastic bag taped to the top
console.

7
Route the power cord through the hole in the
back of cabinet, and plug into the line filter
inside the game.
WILLY CRASH GAME SETUP
Unlock and remove the back door using a H95 key.
Replace the back door.
Peel the protective plastic film from the marquee
artwork, and apply the bonus ticket value desired
to the white outline as shown.
Using a ladder, position the marquee artwork on top of the
game and secure using 8 of the black # 2 square drive screws
from the hardware kit. (4 per side)
The artwork is notched to ease installation.
The game is now set up and ready for play!
Enter menu to adjust settings to your location specific price per play
and ticket payout.
Power on game:
Open the front door and turn on the rocker switch on the power strip.