BROSA Bristol User manual

ASSEMBLY GUIDE
Bristol Desk
v1.0

Components
Upon unpacking your desk from it’s delivery box, you should have the
separate pieces shown below. Follow the steps on the next pages to assemble
your new table.
Table Top
Longer
Leg
Shorter
Leg
Side Rail
Side Rail
A x 4
(Ø8x40)
B x 2
(M8xL95)
C x 2 D x 2
(M8)
E x 2
(Ø38)
H x 6
(5/16xL60)
I x 2
(5/16xL55)
J x 2
(5/16xL30)
K x 10
(Ø8 x Ø14)
L x 1
(5#)
F x 1
14#
G x 1
(10g)
Hardware
What you need

Step 1
1.2 Insert dowels (A) into the outer holes of the longer
legs. It is optional to use the glue over the wooden
dowels.
1.2 Insert threaded rods (B) into the corresponding
holes on the leg making sure to leave around 60-65
millimeters out.
1.3 Insert half lunar washers (C) into the holes on the
side rails. Align side rails with the leg. Fit a nut (D)
into a rod and screw it rmly with the provided
spanner (F).
1.4 Insert plastic caps (E) to cover the lock holes on
the side beams.
A x 4
B x 2
C x 2
A
B
60-65mm
C
D
F
E
Step 1.1
Step 1.2
Step 1.3
Step 1.4
D x 2
E x 2
F x 1
G x 1

2.1 Align the leg structure formed in the previous step
to the underside of the table top. Fit a washer (K) to a
long bolt (H) and screw into the corresponding hole
using allen key (L). Repeat for the remaining holes.
2.2 Align the shorter leg to the underside of the table
top. Fit a washer (K) to a medium bolt (I) and screw
into the higher holes using allen key (L). Repeat for
the second hole.
2.3 Fit a washer (K) to a short bolt (J) and screw into
the lower hole using allen key (L). Repeat for the
second hole.
H x 6
I x 2
J x 2
K x 10
L x 1
Step 2
L
L
L
K
I
J
H
K
K
Step 2.1
Step 2.2
Step 2.3

Step 3
Gently lift the desk and place upright on a level
surface. Enjoy your new desk!