BROSA Magnus 3-Seater Sofa User manual

ASSEMBLY GUIDE
Magnus 3-Seater Sofa
v1.0

Components
Upon unpacking your sofa from it’s delivery box, you should have one single
component (the body of the sofa). Additional components are packed inside
the body, you will learn how to access and utilise these components in the
next steps.
Turn the sofa body so that the underside is facing you. Follow the coloured
string to the component compartment. Unzip this and take out the
additional components, then zip it back up.
Sofa body x 1
Unpacking
A x 4 (Leg)
B x 16 (Bolt)
C x 16 (Washer)
D x 1 (Allen Key)
E x 1 (Center Leg)

Step 1 Align a leg (A) to the underside of the sofa so that
the screw holes are overlapping. Fit a washer (C) to a
bolt (B) and screw into a hole. Repeat for the other
three bolts (B) to t the leg to the body of the sofa.
Turn the bolt with the allen key (D) until it is secure
but do not tighten yet. Repeat for the remaining legs.
Step 2 Screw the center leg (E) it into it’s corresponding slot
in the middle of the sofa and tighten.
D x 1
C x 16
B x 16
A x 4
E x 1
C
B
A
D
E

Step 3 Lift the sofa o the ground and turn it right side up
while being careful not to put any pressure on the
legs while you turn the sofa.
D x 1
Step 4 Place the sofa on a at surface, then sit on the sofa
and shift your weight around until the legs are level
and the sofa does not rock. en use the allen key
(D) to tighten all the bolts. Enjoy your new sofa!