BROSA Parc Bedside Table User manual

ASSEMBLY GUIDE
Parc Bedside Table
v1.0

Components
Upon unpacking your bedside table from it’s delivery box, you should have
the separate pieces shown below. Follow the steps on the next pages to
assemble your new bedside table.
A x 8
Spec: 5/16 x 60mm
B x 8
Spec: Ø8 x Ø14mm
D x 4
Spec: Ø3.5 x 11mm
E x 1
Spec: M5
C x 2
Spec:
Hardware
What you need
1
2
Bedside table x 1 Leg x 4

Step 1
B x 8
E x 1
A x 8
Align a leg (2) to the underside of the bedside table (1)
so that the screw holes are overlapping. Fit a washer
(B) to a bolt (A) and screw into a hole and repeat for
the other bolt to secure the leg in place. Repeat
process for the remaining legs (2) and use the allen
key (E) to tighten all of the bolts (A).
Step 2 Lift the bedside table and turn it upright placing it
rmly down on a level surface. Align a handle (C) to
its corresponding place and secure it with two
screws (D). Repeat for the other handle (C).
D x 4
C x 2
A
B
E
1
2
C
D

Step 3 e bedside table is 45cm wide by 61cm high and
43cm deep and can take up to 60kg maximum
weight on top and 4kg inside each draw. Enjoy your
new bedside table!
61.0cm
45.0cm
43.0cm
60KG
MAX
4KG
MAX
4KG
MAX