BROSA Bruin Wooden Bed Frame User manual

Bruin Wooden
Bed Frame
ASSEMBLY GUIDE
V3

FOR YOUR SAFETY
Lift, don’t drag. This protects
your floor and product.
Avoid loose screws. Tighten
fixtures every few months.
Assembly requires 2 people.
It's always easier with a
friend.
Contact our support online
or call 1300 027 672.
Check the assembly guide
for required components.
?
Assembling this product on
a soft surface protects its
finish.

Components
Before you get started, check you have all of the pieces below.
If anything’s missing, we’ll sort it out right away. Simply visit:
www.brosa.com.au/pages/product-return-and-parts-request
②Foot Board x 1
①Bed Head x 1
③Side Board x 2
③
④Middle Rail x 1
⑤Middle Leg x 2
Slat Set x 4
⑥

Hardware
What You Need
A x 8
(M8 x 20)
B x 2
(M6 x 75)
C x 2
(3/8)
E x 16
(M4 x 25)
F x 2
(M4)
G x 1
(12/13)
D x 2
(M6)
Middle Leg x 2

Insert a hex flange bolt Ainto the hole of the
metal plate on the bed head. Screw it with your
hand and leave out some threads for hanging the
bracket in the next step.
Repeat this for all metal plates on the bed head
① and foot board ②.
Step 1
Ax 8
A
②
①

Align both side boards ③ with the bed head ①
and foot board ②. Make sure the stickers on each
component match as per the diagram below.
Hook the brackets of the side boards to the hex
flange bolts installed in Step 1.
Tighten the hex flange bolts with the spanner G.
Step 2
Gx 1
②
①
③
③
G

Screw the foot stopper Fto the hole on the
bottom of the middle leg ⑤.
Repeat this for the other middle leg.
Step 3
Fx 2
F
⑤

Align a middle leg with the hole on the beam of
the middle rail ④. Insert a long bolt Binto the
hole and make sure it protrudes from the other
side. Attach a flat washer C to the bolt followed
by a nut D. Tighten the nut with the spanner G.
Repeat this for the other middle leg.
Step 4
Bx 2
Cx 2
Dx 2
Gx 1
④
G
D
C
B

Slide the structure formed in Step 4 into the
wooden blocks on the bed head and foot board.
Adjust the stoppers beneath the middle legs to
make them hang approximately 5mm off the
ground.
Step 5
5mm

Fit the slat sets ⑥ between the wooden blocks
on the wooden frame. Make sure the stickers
on each component match as per the diagram.
Step 6
⑥