BROSA Elizabeth Extendable Dining Table User manual

ASSEMBLY GUIDE
Elizabeth Extendable Dining Table
v1.0

Components
Upon unpacking your dining table from its delivery box, you should have the
separate pieces shown below. Follow the steps on the next pages to assemble
your new dining table.
Table top x 1
Stretcher x 1
Corovin storage
bag x 1
Leaf x 1
Leg x 2
Hardware
What you need
G x 8
Spec: Ø8.4 x 2mm
D x 1
Spec: M5
E x 1
Spec: M4
F x 8
Spec: Ø8.4 x 17 x 1.6mm
A x 4
Spec: Ø10 x 48.5mm
B x 4
Spec: M10 x 10mm
C x 8
Spec: M8 x 30mm

Step 1 Insert a steel dowel (A) into both holes in the leg (2)
making sure they are facing the correct direction when
in place. Repeat for the other leg (2).
A x 4
Step 2 Align a leg (2) to the stretcher (3) tting them together
and repeat for the other leg (2). Insert a grub screw (B)
into a hole and use the allen key (D) to tighten. Repeat
for the remaining grub screws (B).
B x 4
D x 1

Step 3 3.1 Ensure that the slides are locked on the underside
of the table top (1) before commencing anything.
3.2 Align the structure formed in Step 2 to the
underside of the table top (1). Fit a lock washer (G) to a
bolt (C) followed by a at washer (F) and screw into a
hole, using the allen key (E) to tighten in place. Repeat
for the remaining bolts (C).
Step 4 Gently lift the table and place upright on a level surface.
Enjoy your new dining table!
C x 8
F x 8
G x 8
E x 1 Step 3.1
Step 3.2
F
G

Step 5 e following steps are instructions on how to fully
extend your table. Remove the leaf (4) from the corovin
storage bag (5) and place on a soft, clean surface.
Step 6 Unlock the slides underneath the table and with
another person, gently pull the two halves of the table
apart, until fully extended.

Step 7 7.1 Gently lower the leaf (4) to be level with the table
top and press it to one side of the table, rst making
sure the pins are aligned to the holes.
7.2 With another person holding the table, push the
other end together with the leaf (4), again making sure
the pins are aligned to the holes. Lock the slides before
moving the table. Note: the slides must always be
locked before moving the table in any way.
Step 7.1
Step 7.2

Step 8 To remove the leaf (4) release the locks and with
another person, gently pull the two halves of the table
apart. Lift the leaf (4) up and out of the table.
Step 9 Place the leaf (4) back into the corovin storage bag (5).

Step 10 Carefully place the corovin storage bag (5) into the built
in storage under the table top as shown. With another
person, push the two halves of the table together and
lock the slides.