BROSA Parc Dresser User manual

ASSEMBLY GUIDE
Parc Dresser
v1.0

Components
Upon unpacking your dresser from it’s delivery box, you should have the
separate pieces shown below. Follow the steps on the next pages to assemble
your new dresser.
1
2
Dresser x 1
Leg x 4
A x 8
Spec: 5/16 x 60mm
B x 8
Spec: Ø8 x Ø14mm
D x 12
Spec: Ø3.5 x 11mm
G x 2
Spec: Ø7 x 26mm
H x 2
Spec: 192 x 26mm
E x 2
Spec: Ø3.8 x 32mm
F x 2
Spec: Ø3.8 x 16mm
I x 1
Spec: M5
C x 6
Spec:
Hardware What you need

Step 1
B x 8
I x 1
A x 8
Align a leg (2) to the underside of the dresser (1) so
that the screw holes are overlapping. Fit a washer (B)
to a bolt (A) and screw into a hole and repeat for the
other bolt to secure the leg in place. Repeat process
for the remaining legs (2) and use the allen key (I) to
tighten all of the bolts (A).
Step 2 Lift the dresser and turn it upright placing it rmly
down on a level surface. Align a handle (C) to its
corresponding place and secure it with two screws (D).
Repeat for the remaining handles (C).
D x 12
C x 6
1
2
A
I
B
C
D

Step 3 Align a strap (H) to the back of the dresser and secure
in place with a screw (F). Repeat for the other strap (H).
Step 4 4.1 At the location where the dresser will be placed,
mark out two holes along the wall where you’ll secure
the straps. With a 7mm drill bit, drill the two holes.
Warning: check the wall for hidden pipes and cables
before drilling holes.
4.2 Insert the expansion bolts (G) into the wall by
hammering it gently into place followed by the screws
(E) to secure the straps to the wall.
H
F
H x 2
F x 2
G x 2
E x 2
Ø7
G
E
Step 4.1
Step 4.2

93.0cm
100.0cm
47.0cm
60KG
MAX
5KG
MAX
Step 5 e dresser is 100cm wide by 93cm high and 47cm
deep and can take up to 60kg maximum weight on top
and 5kg inside each draw. Enjoy your new dresser!