BROSA Nancy Chest of Drawers User manual

ASSEMBLY GUIDE
Nancy Chest of Drawers
v1.0

Components
Before you get started, check you have all of the pieces below. If anything’s
missing, please visit www.brosa.com.au/pages/product-return-and-parts-request
and we’ll sort it out right away.
Hardware
What you need
Legs x 2
Stretcher x 1
Body x 1
B x 3
(Bolt)
(Spec: M6xL50)
A x 13
(Washer)
(Spec: 14x8)
D x 10
(Plastic Cap)
E x 4
(Dowel)
G x 4
(Washer)
(Spec: 10x4)
F x 2
(Mounting Plate)
H x 4
(Screw)
(Spec: 3.5x35)
C x 10
(Bolt)
(Spec: M6xL32)

Step 1
A x 3
B x 3
Align a stretcher to the underside of the body so that the
screw holes are overlapping. Fit a washer (A) to a longer bolt
(B) and screw into a hole using a screwdriver. Repeat for the
other holes.
Step 2
A x 10
C x 10
Align a leg to the underside of the body so that the screw
holes are overlapping. Fit a washer (A) to a bolt (C) and screw
into a hole using a screwdriver. Repeat for other holes then
for the second leg. Cover the bolt holes with the plastic caps
(D).
D x 10
A
B
D
C
A

Step 3
E x 4
Find a nice spot for the chest of drawers and make two holes
in the wall using a drill and 7mm drill bit. Distance of the
holes should be 37mm, 475mm and again 37mm. Height
from the oor around 777mm. Using a hammer insert four
dowels (E) into the holes.
7
37
37
475
E
WALL
≈777

Step 5 Attach the storage to the Mounting Plate.
F
G
H
WALL
WALL
Step 4
F x 2
G x 4
H x 4
Fit a washer (G) to a screw (H) and x the Mounting Plate (F)
to the wall using a screwdriver.

Step 6 Enjoy your new storage!