Coalesse Denizen Round Operating and safety instructions

Page 1 of 9
1066880001 Rev A
ALLEN WRENCH
™
Denizen Round and Oval Table
Touch Latch Assembly Replacement
If you have a problem, question, or request, call
your local dealer, or Steelcase Line 1 at
888.STEELCASE (888.783.3522)
for immediate action by people who want to help you.
(Outside the U.S.A., Canada, Mexico, Puerto Rico,
and the U.S. Virgin Islands, call: 1.616.247.2500)
Or visit our website: www.steelcase.com
©2016 Steelcase Inc.
Grand Rapids, MI 49501
U.S.A.
Printed in U.S.A.

TIP: Place a shim under carpet
to allow a finger hold when
assembled unit is ready to upright.
1WIRE ROUTING
POWER CORD
1. Unplug power cord.
CUTOUTS IN BASE
Page 2 of 9
1066880001 Rev A
2. Using 2 people, flip the table top down.
Note: Protect top surface from scratches
while working on it.
2
Instructions to Replace Mini Touch Latch Assembly
with Magnetic Touch Latch Assembly

3. Disassemble the base by removing (12) screws that attach
base to worksurface. Pull the power cords from the base column.
Page 3 of 9
1066880001 Rev A
SCREWS
3

4. Remove the PVD liner by rotating it until the tabs line up with the slots.
Pull it out by hand. Disassemble the cover by removing (8) screws that
attach cover to worksurface.
Page 4 of 9
1066880001 Rev A
COVER
PVD LINER

5. Disassemble the mini-touch latch bracket by removing two screws.
Use 5/64" Hex Key (Allen Wrench).
Page 5 of 9
1066880001 Rev A
6. Assemble the magnetic touch latch using two screws.
Use 5/64" Hex Key.

7. Assemble the cover to worksurface by reusing the (8) screws that were removed during step #4.
Install dust cover as shown in the picture.
Page 6 of 9
1066880001 Rev A
COVER

8. Route the power cords through the base column hole.
Assemble the base to worksurface by using (12) screws
that were removed during step#3.
Page 7 of 9
1066880001 Rev A
SCREWS
8

Page 8 of 9
1066880001 Rev A
Denizen PVD Lid Touch Latch Assembly
1. Open PVD Lid
2. Remove paper liner from the back of the
self adhesive plate.
3. Attach self adhesive plate on to the bottom
of PVD lid by applying adequate pressure.
Note: Self adhesive plate (PN: Y526083) does not come
with the touch latch. It needs to be ordered separate.
Customer service part number is Y559201SR.
Self adhesive plate
to be flush to edge.
1
2
3

Page 9 of 9
1066880001 Rev A
4. Insert touch latch into bracket as shown
5. Manually thread the nut.
6. Hold the touch latch with fingers and gently
tighten nut using adjustable wrench or
3/8” square drive, 12 point, 2.5 deep socket.
Note: Overtightening the nut could
damage the touch latch.
Note: Strike plate that comes with touch latch
is not required for this assembly.
BRACKET
NUT
TOUCH LATCH
4
5