Coalesse tX2 User manual

P age 1 of 4
939503304 R ev A
tX2 - Flex-Tops, includes Pedestals,
Inside Supports, and End Panels
If you have a problem, question, or request, call
your local dealer, or S teelcas e Line 1 at
888.S T E E L C AS E (888.783.3522)
for immediate action by people who want to help you.
(Outside the U.S .A., C anada, Mexico, P uerto R ico,
and the U.S . Virgin Islands , call: 1.616.247.2500)
Or visit our website: www.s teelcas e.com
©2008 S teelcase Inc.
G rand R apids, MI 49501
U.S .A.
P rinted in U.S .A.
PEDESTAL, page 2
INSIDE SUPPORT, page 4
END PANEL, page 3
2
3
4

Page 2 of 4
939503304 Rev A
INSTALLING A PEDESTAL TO A WORKSURFACE
1. Remove drawers from pedestal.
2. Install Filler Strip on rear of pedestal.
3. Carefully lay top bottom side up onto carpet
or other soft, clean material.
4. Position pedestal as shown, with the filler
strip flush with the back edge of top.
5. Secure with (4) screws provided
through holes in stretchers.
6. Carefully turn assembly over and reinstall
drawers and adjust leveling glides
as needed.
7. Align holes in Wire Manager with pilot holes
in top then secure with screws.
Flush with worksurface
(Flat edge only)
3/4"
(19 mm)
FRONT EDGE
2
Attach
FILLER STRIP
to rear panel of
pedestal with screws.
REAR VIEW
4
Filler strip must be flush
with the back edge of top.
5
1
Ellipse
Bevel
Waterfall
Note: Front edge has different profile options,
each with differing dimensions. Align storage
or end panels from back edge.
*
*
7

Page 3 of 4
939503304 Rev A
5
INSTALLING AN END PANEL TO A WORKSURFACE
1. Carefully lay top bottom side up onto carpet
or other soft, clean material.
2. Assemble filler strip to end panel as shown.
3. Attach a cantilever bracket to end panel.
4. Install (2) angle brackets to end panel.
5. Position the end panel as shown, with the
filler strip flush with rear of top.
6. Secure end panel to worksurface.
7. Carefully turn assembly over and adjust
leveling glides as needed.
2
Attach
FILLER STRIP
to end panel with
(3) screws.
Note: There will be an overhang when
using a wood edge profile top.
Note: Filler strip must be flush
with the back edge of top.
4
3
6
6
FRONT EDGE
REAR EDGE

Page 4 of 4
939503304 Rev A
3
2
INSTALLING AN INSIDE SUPPORT
NOTE: You must use an inside support panel to join and
provide support when two tops join together, or when there
is an unsupported span of more than 62" .
1. Attach (2) angle brackets to support leg.
2. Attach (2) cantilever brackets to support leg.
3. Carefully align tops (bottom side up) into position.
4. Lower support assembly onto tops as shown.
5. Secure inside support to tops.
6. Carefully turn assembly over and adjust
leveling glides as needed.
1
4
5
INSIDE SUPPORT will be centered
on seam of tops with opening toward
the rear. Locate it 3/4" (19 mm)
from rear edge of tops.