Coalesse Lagunitas User manual

Page 1 of 3
902507401 Rev A
Lagunitas™Corner Screen Replacement
If you have a problem, question, or request, call
your local dealer, or Coalesse at 1.800.627.6770
Or visit our website: www.coalesse.com
©2014 Coalesse
San Francisco, California U.S.A.
Printed in U.S.A.

Page 2 of 3
902507401 Rev A
1. Screen removal is best done with the unit laying on its
back. To prevent the unit from getting dirty, lay down a clean
piece of cardboard or plastic and then place the unit onto its
back.
2. Remove two (2) flat head bolts at the front of the bench.
3. Remove two (2) socket head bolts from the rear attachment
bracket as shown.
NOTE: Make sure to have a person supporting the screen,
so it doesn’t fall over. At this point the screen is only held in
place with a panel clip. Failure to support the screen will
damage this clip.
4. With the bolts removed, the screen will be loose, but is
still joined to the adjacent screen with a screen ganging clip
roughly 4 inches down from the top of the screen. To remove
this clip, insert a pair of needle nose pliers between the
screens and compress the clip. With the clip compressed,
you should be able to pull the screens apart.
NOTE: If the screens don’t release, try to push
the screens together while compressing the
panel clip. This will remove any tension on the
clip and you should be able to pull the screens apart.
NOTE: If you don’t have a pair of needle nose pliers, a flat
head screwdriver can be used to push down on the clip to
release it.
1
2
3
4
FLAT HEAD BOLT
SOCKET HEAD BOLT
SCREEN
GANGING CLIP

Page 3 of 3
902507401 Rev A
5. To reinstall the corner screen leave the unit on its back
and install the panel clip into the adjacent screen (ensure
the overlapping joint is facing upwards). Push the clip into
the screen until a “click” is heard and verify that the clip
can’t be pulled from the screen.
6. Carefully insert the exposed end of the panel clip into
the opening in the corner screen until a “click” is heard. To
ensure the clip is fully engaged, pull on the screens to
ensure they don’t come apart.
7. Install the two (2) flat head bolts at the front of the bench
but DO NOT tighten.
8. Install the two (2) socket head bolts into the rear
attachment bracket and tighten to 130 in-lbs.
9. Go back to the two (2) flat head bolts that were installed
in step 7 and tighten them to 130 in-lbs.
10. Unit can now be placed upright and the glides
should be leveled.
10
9
8
FLAT HEAD BOLT
SOCKET HEAD BOLT
7
OVERLAPPING
JOINT
5
6
SCREEN
GANGING CLIP
CLICK
CLICK