Coalesse Chord Use and care manual

Page 1 of 5
102439601 Rev A
5mm Hex Drive
Chord™Chair Arm Replacement
If you have a problem, question, or request, call
your local dealer, or Coalesse at 1.800.627.6770
Or visit our website: www.coalesse.com
©2016 Coalesse
San Francisco, California U.S.A.
Printed in U.S.A.
Staple Puller
1. Carefully pick up the chair
with both hands and place on
its side on a clean, scratch
resistant surface.
2. Use staple puller and start
removing staples at bottom of
the seat at end of arm.

Page 2 of 5
102439601 Rev A
5. Use screwdriver gun and 5mm bit start loosen three (3)
screws removing the old arm from the chair.
3. Use your hands and start to remove
the welt at the bottom of the seat.
4. Slowly begin pulling welt away from arm. Be careful around the back’s area. Use your
finger and press firmly against the welt while pulling with your other hand. This will help
avoid the back cover tearing. Continue to other side and remove the welt from chair.

Page 3 of 5
102439601 Rev A
7. While the chair still at side position, use clean rag to
remove any burr or grease inside the arm groove.
6. Reverse step #5 to attach the new arm
to the chair.
8. Use hot melt gun and apply adhesive
inside the back’s groove.
Attaching New Arm

Page 4 of 5
102439601 Rev A
11. Repeat steps 8 & 9 to attach the welt to the arm.
9. Hold welt cord at the seam line and press
starting at center applying cord working your
way both left and right.
10. Turn the chair on its side.

Page 5 of 5
102439601 Rev A
14. Use staple gun and attached end of cord and
secure black fabric.
12. The welt should extend out approx 3” from end of arm. This amount is needed
to complete secure the welt to the bottom of the seat. Cut any excess weld.
13. Insert the welt inside the black fabric.