Crosswater Fenmore 28-51 User manual

28-51
llen Wrench
For eas installation you will need:
●To read the installation completely before
beginning.
●To read all warnings, care, and maintenance information.
Installation Instructions
Fenmore Robe Hook
28-51
4 1
Φ 21
8"
3
4"
13
4"21
4"
13
8"
25
8"

Determine the location of the robe
hook.
Align bracket and mark drill holes
in desired location.
Drill 1/4" holes in marked locations.
Drive the wall anchors into the drilled
holes with a Phillips screwdriver.
Place the mounting bracket over
the wall anchors. Secure them to
the wall using the supplied screws.
Temporarily place the robe hook
on the mounting bracket to check
alignment. If necessary, loosen the
screws and realign the mounting
bracket.
Place robe hook on the mounting
brackets. Secure it to the wall using
the bottom set screw.
00072
00101** & 00105**
00839
Paper holder
Anchors,Bracket and mounting screws
Set screws
Note:
The suffixes of ** represent different finishes
Rinse away any traces of soap and gently dry with a clean, soft cloth after each use. Rinse completely with water and
dry any overspray. This will maintain the finish and avoid water spotting.
To remove mineral deposits, use a 50/50 solution of white vinegar and water. Do not allow the solution to soak on the
product.
Simichrome Polish® contains a protective film to enhance maintenance and is helpful in preventing water spot buildup.
Follow instructions to ensure optimum results.
Never use an abrasive material such as a brush or scouring pad to clean the surface. The use of abrasive cleaners,
cleansers or disinfectants will alter the surface finish and void the warranty.
Do not allow certain materials such as toothpaste, cologne, shaving cream, nail polish remover, vinegar, wine, drain
and glass cleaners to remain on the surface. Prolonged contact will alter surface finishes and void the warranty.
We DO NOT recommend using any household cleaners as many can cause damage to the finish.
Please see the website for care instructions for specific finishes.
Warranty
For further information contact Crosswater , 393 Fortune Blvd., Milford, MA 01757 www.crosswater .com
Toll free number: 844-XWATER-1 (844-992-8371) tel: 508-381- fax: [phone] email: technical@crosswater .com
Issue date: 01092022
28-51 28-51
2 3
2
3
1

Determine the location of the robe
hook.
Align bracket and mark drill holes
in desired location.
Drill 1/4" holes in marked locations.
Drive the wall anchors into the drilled
holes with a Phillips screwdriver.
Place the mounting bracket over
the wall anchors. Secure them to
the wall using the supplied screws.
Temporarily place the robe hook
on the mounting bracket to check
alignment. If necessary, loosen the
screws and realign the mounting
bracket.
Place robe hook on the mounting
brackets. Secure it to the wall using
the bottom set screw.
00072
00101** & 00105**
00839
Paper holder
Anchors,Bracket and mounting screws
Set screws
Note:
The suffixes of ** represent different finishes
Rinse away any traces of soap and gently dry with a clean, soft cloth after each use. Rinse completely with water and
dry any overspray. This will maintain the finish and avoid water spotting.
To remove mineral deposits, use a 50/50 solution of white vinegar and water. Do not allow the solution to soak on the
product.
Simichrome Polish® contains a protective film to enhance maintenance and is helpful in preventing water spot buildup.
Follow instructions to ensure optimum results.
Never use an abrasive material such as a brush or scouring pad to clean the surface. The use of abrasive cleaners,
cleansers or disinfectants will alter the surface finish and void the warranty.
Do not allow certain materials such as toothpaste, cologne, shaving cream, nail polish remover, vinegar, wine, drain
and glass cleaners to remain on the surface. Prolonged contact will alter surface finishes and void the warranty.
We DO NOT recommend using any household cleaners as many can cause damage to the finish.
Please see the website for care instructions for specific finishes.
Warranty
For further information contact Crosswater , 393 Fortune Blvd., Milford, MA 01757 www.crosswater .com
Toll free number: 844-XWATER-1 (844-992-8371) tel: 508-381- fax: [phone] email: technical@crosswater .com
Issue date: 01092022
28-51 28-51
2 3
2
3
1

28-51
llen Wrench
For eas installation you will need:
●To read the installation completely before
beginning.
●To read all warnings, care, and maintenance information.
Installation Instructions
Fenmore Robe Hook
28-51
4 1
Φ 21
8"
3
4"
13
4"21
4"
13
8"
25
8"