Crosswater US-L1 User manual

Installation Instructions
Tape
measure
Safety
glasses
Adjustable
wrench
Flat head
screwdriver
8mm
drill
Pencil Spirit
level
Silicone
sealant
Tools required
x4 x4 x4 x4 x8 x4 x4 x4 x4 x8 x1
Parts supplied
Installation notes
The installation must comply with all plumbing codes including local
codes and be installed by a licensed plumbing contractor. Assemble
the bathtub on a mat to protect against damage to the tub surface.
Note: Bathtub diagrams shown are for reference only.
WARNING! Please check for any hidden pipes and cables, electric
or otherwise,before drilling holes in a wall or floor.
Introduction
The claw feet have been fully inspected throughout the production
process and only leaves our factory after a 15-step QC process.
Carefully remove the claw feet from the box and check that all parts
have been supplied.
Before beginning installation, please check for any damage that may
have occurred during transport.
Note: Damage claims cannot be made during or after
installation.
Improper installation shall result in loss of warranty in case of
damage caused by impacts or rubbing against rough surfaces.
IMPORTANT: Please read these instructions carefully before
beginningand retain for future reference.
We do not accept responsibility for any problems that may occur
through incorrect installation.
Claw Bathtub Feet
US-L1

Issue date: 15092019
Warranty - This Crosswater London product is covered by a limited lifetime warranty. For full details, terms and conditions please visit our website.
For further information contact:Crosswater London, 393 Fortune Blvd., Milford, MA 01757
Toll free number: 844-XWATER-1 (844-992-8371) tel: [phone] fax: [phone]
www.crosswaterlondon.com
email: [e-mail]
2Installation
1Installation
lDo not overtighten