Decon wheel MEM6433P User manual

2021-07-01
Assembly instructions for Etac Crissy
MEM6433P and MEM6434P
1. Remove wheels and brakes.
2. Check the correct placement for the eMove, and that it is,
Axle Ø12,0 x 51 with Part Number: XOE-2530E-BO
Spacer with Part Number: XOE-25383-00300052
Stop pins are assembled with Part Number: 320003
8
9
10

2021-07-01
Direction of travel
3. Assembly the plate (right side) according to picture.
Placement Options:
It can be mounted in all position, but only the centre located in the respective holes in
the frame.

2021-07-01
4. See picture above for mount the bracket.
Parts for right side mounting:
Item No. Part Number Qty Description
1 100 400 017 1 Spacer
2 405239 1 Nordlock Washer M16
3 XSM16M 1 Nut M16 low
4 MED4006 Rev2 1 Support Plate Outside
5 MED4007 Rev2 1 Support Plate inside
6 320020 1 Bracket
7 HW063 1 Sleeve
8 XOE-25383-00 1 Spacer
9 93440-120520 1 Circlip
10 320003 1 Bracket with Pin
Note! If you only order the mounting set, the axle, axle spacer and the circlip are not
included, for replacement see the service manual.
5. Now you can assemble the backrest battery bag.
7
2
1
6
5
4
3

2021-07-01
Om inget annat specificeras, använd följande åtdragningsmoment.
Unless otherwise specified, use the following tightening torque.
Metriska grovgängor, stål.
Metric coarse threads, steel.
Gänga / Thread
Åtdragningsmoment / Tightening torque
M3
1,2 Nm
M4
3 Nm
M5
6 Nm
M6
10 Nm
M8
25 Nm
M10
50 Nm
M12
85 Nm
Navhylsa.
Sleeve.
Gänga / Thread
Åtdragningsmoment / Tightening torque
M16x1
30 Nm
M18x1
40 Nm