DITEC ENTREMATIC HA9 User manual

Quick Start Guide
Ditec HA9 Low Energy
Swing Operator
1020059-EN-US
1.0
© Entrematic 2019 Technical data subject to change without notice.
1of 6
①Prepare unit for mounting.
Mark spindle center on the bottom edge of header before
removing. This will help you to relocate the Motor/Gearbox
when time for reinstalling.
⚠

2 of 6
1020059
② Mount header backer plate.
PUSH
PULL
③Connect power.
The mains connection must remain
isolated until the wiring is completed.
⚠
The header must be securely anchored to the
frame and wall. It must be strong enough to
support 200 lbs. (90.7kg), place anchors 12" to 16"
(304.8mm to 406.4mm) apart.
⚠

3 of 6
1020059
④ Change unit configuration.

4 of 6
1020059
⑤ Reinstall motor/gearbox.
Spindle must be located as shown.
⚠
Tighten nuts in a crisscross pattern
starting with Top Center Nut.
⚠
⑥ Install arm.
PUSH
Measure from hinge center to
first whole on Door Shoe.
⚠
Rod must extend 1” (25.4mm)
past 2nd setscrew.
⚠
The Rod to be perpendicular
to the door and the Main Arm
at 80°at closed position.
⚠
90°
5in [ 128mm ]

5 of 6
1020059
PULL
Determine spacer requirement and
orientation. Max reveal is 2 ⅜” (60mm).
⚠
⚠
Roller track must
cover these marks.
Pull Arm
Do not tighten the socket
cap screw at this time.

6 of 6
1020059
7a
⑦ Tune operator.
7b
7c
7d
7e
7f
7g
7h
7i
⑧ Install header cover.
Use a #8-18 x ½” L Self-Drilling Screw.
⚠