fantastic furniture VOGUE User manual

Assembly Instructions
VOGUE
30KG
10KG
COFFEE TABLE RECTANGLE LIFT UP
Ver.1.1

Page 2
2
3
56
Read Instructions carefully.
Lay out all of the components on a soft surface
as if you were preparing to do a jigsaw puzzle.
Carefully identify each component, especially
those that are similar. The most common mistake
is getting things back to front.
Separate and identify each component from the
hardware pack and rest each one in its proper
WARNINGWARNING
Check no parts are missing.
4
fully tighten screws（leave slightly
loose.When the item is fully assembled
tighten the screws - but do not over tighten.
FAILURE TO FOLLOW THESE BASIC STEPS CAN LEAD TO DAMAGE
THAT IS NOT COVERED BY YOUR WARRANTY
If glue is required DO NOT set until you are
certain that the parts belong together.

(Tools not provided)
Phillips Head Screwdriver
Flat Head Screwdriver
Mallet
What You Need
Page 3
(H1)
14 x Cam olt
(H2)
14 x Cam Nut
(H3)
8 x Dowel
(H4)
4 x olt
(H5)
12 x Screw
(H6)
4 x Spring Washer
(H7)
4 x Flat Washer
(H8)
14 x Cam Cap
To Assemble the Body
Side
Bottom
Support
Allen key provided
Please make sure you have all these parts before you start.
Table Top With Lift
Mechanism (P1)
Panel(P2)
Side
Panel(P2)
Panel(P3)
Frame(P4)
BB


(H3)
8
(H1)
x14
(H2)
(H8) x14
Step 1
(P2)x2
14 x Cam Nut
14 x Cam Cap
8 x Dowel
14 x Cam bolt
You will need:
Step 2
You will need:
(P2)
(P2)
(P1)
Page 4
(H1)
(H3)
(H2)
(H8)
Attach each 7 x Cam Bolts (H1) and
4 x Dowels (H3) to each Side Panel (P2).
x
Put 14 x Cam Nut into the holes of table top
(P1). Make sure the arrows point towards the
incoming bolt.
Turn the cam clockwise to lock. Cover
the cam nut by using cam cap (H8).
This is how a cam nut works........
The head of the cam
bolt goes into the
open mouth of the
cam nut. You then turn
the cam nut so it
tightens over the bolt.
Attach the side panels(P2).

12 x Screw
4 x Spring Washer
4 x Flat Washer
(H5) x12
(H4)
(H6)
x4
(H7)
(P3)
Step 3
You will need:
12 x olt
You will need:
Step 4
1 x Allen key
(P4)
Page 5
(H5)
(H4)
(H6)
(H7)
Screw on the bottom panel (P3) by using screw (H5) as shown.
Place the support frame (P4) onto the bottom
panel (P3) and attach by using flat washer
(H7), spring washer (H6) and bolt (H4) as shown.
B

Step 5
Page 6
Turn over carefully.
The job is now complete!
In the interest of our environment
Please dispose of all packaging thoughtfully
Make sure the top does not open
during turning to prevent damage.