FLOS ROMEO MOON/SOFT F User manual

INSTRUCTION FOR CORRECT INSTALLATION AND USE
WARNING!
Thesafetyofthisappliancecanonlybeguaranteediftheseinstructionsarefollowedduringinstallationanduse.Therefore,
please keep a copy of these instructions for later reference.
REMARKS
- Make sure the mains power supply has been disconnected before installing the appliance or carrying out any work on
it.
-If not familiar with electrical connections, contact a qualified electrician.
- The appliance may in no way be modified or tampered with, any modification may compromise safety causing the
appliance to become dangerous. FLOS declines all responsibility for products that are modified.
TECHNICALDATA
USAVERSION - Halogen incandescent lamp Max. 150W E26 coupling type T.
120VVERSION - Halogen incandescent lamp Max. 250W E26 coupling type T.
JAPVERSION - Halogen incandescent lamp Max. 250W E26 coupling type T.
CLEANINGINSTRUCTIONS
- Use only a soft cloth to clean the appliance, dampened with water and soap or mild cleanser if needed for resistant dirt.
-Warning: do not use alcohol or other solvents.
02-28-06 Cod.08090
ROMEO MOON/SOFT F
1
FLOSUSA
UL Listed
C-UL Listed
Fig.1 Fig.2 Fig.3
Fig.1 Loosen the three screws on the steam base (A). Insert the screws into keyhole slots in base (B) and turn clockwise.
Tighten the three screws securely.
Fig.2 Takethefixturestemandpassthecord(C)withdimmerthroughtheholeofthebaseplate.Feedthecord(C)through
the slot in the base and then snap the cord (C) into the clip. Place the fixture on the floor.
Fig.3 Position the plastic ring (D) onto the three support arms (E). For the Romeo Moon glass shade, use the flat-head
screws (F) to fasten the plastic ring (D) to the support arms (E).
AB
A
B
C
D
F
E

2
Fig.3a Fig.4 Fig.5
Fig.6 Fig.6a Fig.6b
Fig.3a For the Romeo Soft fabric shade, use the pin screws (G) to fasten the plastic ring (D) to the support arms (E).
Fig.4 Insert internal diffuser cone (H).
Fig.5 Insert light bulb (I).
Fig.6 For the Romeo Moon, place the glass shade (P) onto the plastic ring (D). Also for the Romeo Moon, then position
the glass disc (M) firmly into the glass shade.
Fig.6a For the Romeo Soft shade (N), unscrew the small fixing rollers (Q) from the hooks (R) of the fabric crown.
Fig.6b Locatethethree hooksintothelarge, closedbottomholesin theplasticring(D) andthenscrewup thefixingrollers
again. Also for the Romeo Soft shade, position the glass disc (O) onto the three locating pins. Plug in the fixture.
DG
E
H
I
M
L
D
P
R
QG
O
D
N