Glow Bricks 21054 User manual

1

2
Take off the top L-shaped top, remove the 2x3 and 2x4 plates and replaced
by the lighting parts (beware the direction of the wire)
First of all, split the whole building to 3 separate parts, then take this lighting
part for the left side building

Install the 1x8, 1x2 and 1x1 as shown
Restore the L-shaped top, remove the squared top and install one of the 1x4 plate
3

Now it’s turn for the right-handed side, take this lighting part out
4
Then install the rest 2 1x4 plates, and this part would be finished

Remove the L-shaped top and install the 1x4 at the end as shown
5
Put the top back, remove the other 2 tops and install the rest plates like this
Restore the top then this part is done

Now it’s turn for the middle building
Remove the top first
6

Then install the lighting plates
Then stick the lighting bar as shown
7

8
Put the top back and remove the following parts
Then stick the short lighting bar here

9
Adjust the wire and pull the lighting round plate to the front
Install the lighting round plate then restore all the parts removed

10
At last combine all the buildings and connect the with the USB cable and that’s done
For more AMAZING LED Light Kits visit
www.brickloot.com