Glow Bricks Lego 21035 User manual

1

2
First, split the whole building as shown

Stick the led bars under the grey round tile
Watch out the short bar has to be sticked right as the edge, otherwise it would be
blocked by the parts below when restoring back
3
Remove the round plate and the tiles and take this lighting parts

It should be look like this when restoring the round tile
4
Put the round tile and the other tiles back

5
Settle the wire with connector at the back, restore the parts above and assemble
the lighting plate, stable the wires in between the studs then restore the surface
wall

For the other lighting parts, replace them with the correspond parts
6
Then put the clear black tiles on the lights

7
Assemble the parts from previous step to the building then restore the removed
parts from step 1

8
For the remain 1x2 white lighting plates, assemble them on the top as shown

At last connect with the USB cable and it’s done
9
Hide the cable at the shown area in between the studs and cover by the brick